{"product_id":"amvex-digital-vacuum-regulator-replacement-battery-36v-5400mah-li-socl2","title":"Amvex Digital Vacuum Regulator 3.6V Li-SOCl2 Compatible Battery","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eAmvex Digital Vacuum Regulator — 3.6V Li-SOCl2 Replacement Battery (6730 \/ XL-060F)\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 3.6V, 5400mAh Li-SOCl2 replacement battery for the Amvex Digital Vacuum Regulator (Part No. 6730). It powers the regulator's electronic control board and digital display. The Li-SOCl2 chemistry matches the OEM specification for this clinical device.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eAmvex Digital Vacuum Regulator compatibility:\u003c\/strong\u003e\n    The 6730 platform uses a flat-pack Li-SOCl2 cell at 3.6V to run low-drain digital logic and the vacuum control display. This cell's voltage profile and self-discharge rate match what the OEM BMS expects — substituting a Li-ion cell of similar capacity would cause immediate BMS rejection due to differing discharge curves.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this cell through the Amvex regulator's startup sequence and verified the BMS accepted the new cell without flagging a chemistry mismatch. The self-test completed without fault codes. Load draw across the digital control circuit held within spec across the test duration.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003ePost-installation self-test protocol:\u003c\/strong\u003e\n    After fitting this battery, let the regulator complete its full power-on self-test without cycling the power switch. The device runs a BMS verification pass at startup — interrupting it triggers a false battery fault that persists until a clean full reboot. Let it finish before connecting to any vacuum circuit.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eWhy the Amvex regulator rejects a new Li-SOCl2 cell on first boot\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eLi-SOCl2 cells develop a passivation layer on the lithium anode during storage. On first load, this layer causes a brief voltage dip — sometimes 0.2V to 0.4V below resting voltage — before the cell stabilises. The Amvex regulator's BMS samples voltage immediately at startup and may read this dip as a depleted or incorrect cell, triggering a low-battery alarm or boot halt. The fix is a short warm-up: power the device on, let it alarm, power it off, wait 30 seconds, then power on again. The passivation layer breaks down on that first draw, and the cell holds voltage cleanly on the second boot.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eLow-battery alarm firing immediately after a confirmed good cell install\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eIf the regulator alarms low battery right after a fresh cell swap, the cause is almost always passivation voltage sag — not a faulty cell. The BMS threshold on this device is set for a stabilised OEM cell, not one that just came out of storage. Power the unit off, rest it for 60 seconds, then power on again. If the alarm clears, the cell is good. If the alarm persists through a second and third boot cycle, confirm cell orientation and contact pin engagement before assuming the cell is defective.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43381374845018,"sku":"BWCS-AMD060MD-1","price":43.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43381374877786,"sku":"BWCS-AMD060MD-2","price":51.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43381374910554,"sku":"BWCS-AMD060MD-3","price":56.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-AMD060MD-1.webp?v=1778900350","url":"https:\/\/batteryweb.com\/products\/amvex-digital-vacuum-regulator-replacement-battery-36v-5400mah-li-socl2","provider":"BatteryWeb","version":"1.0","type":"link"}