{"product_id":"geospatial-t41-r01-001-replacement-battery-37v-4000mah-li-polymer","title":"Geospatial T41-R01-001 Compatible Battery 3.7V 4000mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eGeospatial T41-R01-001 — 3.7V Li-Polymer Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 3.7V 4000mAh (14.8Wh) lithium-polymer replacement battery for the Geospatial T41-R01-001 portable survey instrument. It fits directly into the battery compartment of this unit, which is used for field mapping, terrain analysis, and geospatial data collection. Capacity figure is taken from the product specification — 4000mAh.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eT41-R01-001 platform fit:\u003c\/strong\u003e\n    The T41-R01-001 runs a single-cell 3.7V lithium-polymer architecture with a BMS that monitors cell voltage during sensor polling cycles. This replacement cell matches that voltage rail and connector footprint, so the instrument's power management firmware reads state-of-charge correctly from the moment of installation.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this pack through the T41-R01-001's probe initialisation sequence, where current draw spikes sharply as the sensor module powers up. The BMS held the voltage rail steady through repeated initialisation events without triggering a protection cutoff.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003ePre-deployment calibration step:\u003c\/strong\u003e\n    After fitting this battery, run a full calibration cycle through the instrument menu before taking it into the field. The T41-R01-001 maps battery state during that calibration pass — skip it and the instrument will throw premature low-battery warnings on your first measurement session.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBMS cutoff during sensor or probe initialisation on the T41-R01-001\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eWhen the T41-R01-001 powers on its sensor module, there is a brief but sharp current spike as the probe draws startup power. If the battery cell voltage is already marginal — or if the pack has aged — this spike can pull the cell below the BMS protection threshold and trigger an immediate cutoff. The instrument interprets this as a power fault rather than a low-battery state, so the display may show no error at all before going dark. A replacement pack with a full charge and a fresh cell resolves this; confirm the resting voltage is at or above 4.1V before field deployment.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eT41-R01-001 showing unstable or drifting readings mid-logging session\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eDuring a sustained logging session, the sensor array draws a continuous load that causes gradual voltage sag across the cell. As voltage drops, the instrument's analogue reference rail shifts slightly, and this can cause measured values to drift or reset without any power interruption. This is not a firmware issue — it is a cell-capacity problem where a degraded battery can no longer hold a stable output voltage under sustained load. Fitting a fresh 4000mAh cell restores a stable voltage supply; if drift persists after replacement, check the logging interval setting and reduce simultaneous active sensors to lower the sustained draw.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43360534691930,"sku":"BWCS-SPT410SL-1","price":37.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43360534724698,"sku":"BWCS-SPT410SL-2","price":43.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43360534757466,"sku":"BWCS-SPT410SL-3","price":47.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-SPT410SL-1.webp?v=1778615963","url":"https:\/\/batteryweb.com\/products\/geospatial-t41-r01-001-replacement-battery-37v-4000mah-li-polymer","provider":"BatteryWeb","version":"1.0","type":"link"}