{"product_id":"gp-replacement-battery-36v-700mah-ni-mh","title":"GP 3.6V Cordless Phone Replacement Battery 700mAh GP70AAAH3BX","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eGP GP70AAAH3BX \/ GP75AAAH3BX — 3.6V Ni-MH Replacement Battery for Cordless Phones\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 3.6V, 700mAh Ni-MH replacement battery pack for GP-compatible cordless DECT handsets. It matches the GP70AAAH3BX and GP75AAAH3BX part numbers and replaces the original cell pack inside the handset. When the original battery stops holding a charge, this restores the handset to full operation.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eGP70AAAH3BX and GP75AAAH3BX compatibility:\u003c\/strong\u003e\n    Both part numbers share the same 3.6V cell configuration, connector pinout, and physical footprint — three AAA-sized Ni-MH cells in a flat inline arrangement. The base station charge circuit accepts either variant without modification.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this pack through charge and discharge on a cordless phone base station. The BMS accepted charge without triggering an error light, and voltage held stable above 3.2V through the discharge curve at standby draw rates.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eFirst-charge protocol for Ni-MH cordless packs:\u003c\/strong\u003e\n    After installing, seat the handset in the base and leave it on charge for a full 16 hours before first use. Ni-MH cells in cordless phones need a slow, uninterrupted initial charge to reach rated capacity — a short first charge locks in lower capacity from the start.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBase station showing no charge or error light on a new Ni-MH pack\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eMany cordless base stations use delta-peak detection to confirm a battery is accepting charge. A new Ni-MH pack that has sat in storage can drop below the voltage threshold the base expects before it initiates a charge cycle. The base reads this as a fault rather than a low battery. To recover, some handsets allow you to trigger a manual charge by holding the battery contacts with a 3.6V source for 30 seconds to bring the pack above the acceptance floor — check your handset manual for a forced-charge or reset mode.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eTalk time shorter than the original battery for the first few cycles\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eNi-MH cells do not deliver rated capacity on the first discharge cycle — this is normal chemistry, not a defective pack. Capacity builds over three to five full charge-and-discharge cycles as the cells condition. A pack showing short talk time on day one should be fully discharged until the handset shows low battery, then fully charged for 16 hours, and repeated for at least three cycles. By cycle four, voltage at end-of-charge should reach 4.2–4.5V across the pack.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43339873157210,"sku":"BWCS-CPB1024-1","price":22.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43339873189978,"sku":"BWCS-CPB1024-2","price":25.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43339873222746,"sku":"BWCS-CPB1024-3","price":27.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-CPB1024-1.webp?v=1778367024","url":"https:\/\/batteryweb.com\/products\/gp-replacement-battery-36v-700mah-ni-mh","provider":"BatteryWeb","version":"1.0","type":"link"}