{"product_id":"kobot-rv351-replacement-battery-144v-2600mah-li-ion","title":"KOBOT RV351 Replacement Battery 14.4V 2600mAh Li-ion","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eKOBOT RV351 \/ RV353 — 14.4V Li-ion Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 14.4V 2600mAh Li-ion battery for the KOBOT RV351 and RV353 robotic vacuum cleaners. It powers the drive motors, suction fan, and navigation electronics. When the original cell degrades, suction drops early in the cycle and the unit returns to dock sooner than it should.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eRV351 and RV353 compatibility:\u003c\/strong\u003e\n    Both models run the same 14.4V battery rail and use an identical connector and BMS communication protocol. One replacement cell covers both units without any wiring or adapter changes.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this battery through motor-start loads and sustained suction draws. The BMS held voltage above the cutoff threshold under continuous operation and recovered cleanly from the inrush current spike at startup.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eDock charging habit for RV-series units:\u003c\/strong\u003e\n    Do not leave the RV351 or RV353 sitting on the dock between cleaning sessions permanently. These units trickle-charge continuously when docked, which degrades cell capacity faster than intermittent charge cycles. Charge to full, run a cleaning session, then return to dock only when the battery needs replenishing.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eSuction dropping before the battery indicator reaches low\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThe RV351 draws higher current through the suction motor when the filter is partially blocked. As cell voltage sags under that elevated load, the BMS steps down power delivery before the indicator circuit registers a low-battery state. The vacuum appears to lose suction mid-session while the display still shows adequate charge. Clean the filter first — if suction restores after a filter clean, the battery is fine; if sag continues on a clean filter, the cell has lost usable capacity and needs replacement.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eMotor cutting out and self-recovering during a cleaning session\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis is a BMS overcurrent trip, not a mechanical fault. When the brush roll snags debris or carpet fibres restrict airflow, current draw spikes above the BMS protection threshold and the circuit opens to prevent cell damage. The RV351 pauses, the BMS resets after a few seconds, and the motor restarts. Clear the brush roll and check that the filter is not clogged — both restrictions push current draw into the trip range. If cut-outs continue on a clear brush roll and clean filter, verify the replacement battery is seated fully and the terminal voltage at startup reads at least 14.0V.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43426425536602,"sku":"BWCS-TRQ300VX-1","price":50.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43426425569370,"sku":"BWCS-TRQ300VX-2","price":59.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43426425602138,"sku":"BWCS-TRQ300VX-3","price":66.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-TRQ300VX-1.webp?v=1779933223","url":"https:\/\/batteryweb.com\/products\/kobot-rv351-replacement-battery-144v-2600mah-li-ion","provider":"BatteryWeb","version":"1.0","type":"link"}