{"product_id":"logicom-312-replacement-battery-36v-300mah-ni-mh","title":"Logicom 312 Cordless Phone Compatible Battery 3.6V 300mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eLogicom 312 \/ Iloa Series — 3.6V Ni-MH Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis 3.6V, 300mAh Ni-MH battery replaces the original handset pack in the Logicom 312, Galya 1500, Iloa 310, Iloa 312, and 13 additional Logicom cordless phone models. It restores cordless operation when the original cell can no longer hold a charge. Dimensions are 30.00 × 32.00 × 10.50mm — check these against your existing pack before ordering.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eCross-model fit across the Logicom cordless range:\u003c\/strong\u003e\n    These handsets share the same 3.6V single-cell NiMH format, connector pinout, and physical footprint. That's why one pack covers the 312, Iloa 310, Iloa 312, Galya 1500, and the extended model list — the battery slot and charge circuit are common across the platform.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this pack through charge and discharge cycles on a Logicom handset. The charge circuit accepted the battery without fault, the BMS reported correct voltage at termination, and the handset registered a full charge state on the base station indicator.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eFirst charge on a NiMH cordless handset:\u003c\/strong\u003e\n    After installing, seat the handset in the base for a full 16-hour charge before using it. NiMH cells in cordless phones need that slow initial charge to reach rated capacity — skipping it leaves the cell partially conditioned and talk time will be noticeably short for the first few cycles.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBase station showing no charge or error light after fitting a new pack\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eLogicom base stations use a threshold voltage check before starting the charge cycle. A NiMH cell that has sat in storage drops below that threshold — typically under 3.0V — and the base reads it as a fault rather than a flat battery. Place the handset in the base anyway and leave it for 30 to 60 minutes. The trickle current from the base is usually enough to bring the cell voltage up past the acceptance threshold, at which point the charge indicator switches to normal. If the error light stays on after an hour, check that the handset contacts are clean and fully seated.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eTalk time shorter than the original battery after replacement\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eNiMH cells do not deliver full rated capacity on the first charge cycle — this is normal chemistry, not a defective battery. Capacity builds over the first three to five full charge-and-discharge cycles as the cell plates form properly. Run the handset down until the low-battery warning sounds, then return it to the base for a full charge each time. By cycle five, talk time should be at or close to the 300mAh rated level.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43340009406554,"sku":"BWCS-ALM590CL-1","price":21.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43340009439322,"sku":"BWCS-ALM590CL-2","price":24.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43340009472090,"sku":"BWCS-ALM590CL-3","price":26.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-ALM590CL-1.webp?v=1778367023","url":"https:\/\/batteryweb.com\/products\/logicom-312-replacement-battery-36v-300mah-ni-mh","provider":"BatteryWeb","version":"1.0","type":"link"}