{"product_id":"maginon-dc-5300-replacement-battery-37v-1050mah-li-ion","title":"Maginon DC-5300 Replacement Battery 3.7V 1050mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eMaginon DC-5300 Series — 3.7V Li-ion Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis 3.7V, 1050mAh (3.89Wh) lithium-ion cell replaces the original battery in the Maginon DC-5300, DC-5350, DC-5390, and DC-6300 compact digital cameras. These point-and-shoot cameras share a common battery bay and connector format across the series. Capacity figures are taken directly from product specification — not extrapolated from third-party sources.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eDC-5300 series compatibility:\u003c\/strong\u003e\n    The DC-5300, DC-5350, DC-5390, and DC-6300 all draw from the same 3.7V single-cell rail with identical physical dimensions — 53.20 x 35.30 x 7.10mm. The battery management system on each body reads cell voltage through the same contact layout, so one cell covers all four models.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this cell through charge and discharge using compatible camera body charging. The BMS accepted the cell without fault flags, and the protection circuit responded correctly to end-of-discharge cutoff without triggering premature shutoff under normal shooting load.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eFirst-cycle BMS initialisation:\u003c\/strong\u003e\n    Run one full charge inside the camera body or OEM charger before your first shoot. Some Maginon camera bodies map the battery-remaining indicator against an internal charge curve — skipping this step can cause the display to show inaccurate remaining charge until that calibration cycle completes.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eFlash recycling slowing down before the battery indicator drops\u003c\/h3\u003e\n\n  \u003cp class=\"bpw-desc-p\"\u003eThe DC-5300's flash capacitor pulls a sharp current spike each time it recharges between shots. As a lithium-ion cell ages — or if a replacement cell has a slightly elevated internal resistance — the camera body receives less current per recharge cycle than the capacitor demands. This shows up as longer recycling gaps between flash shots, well before the battery percentage indicator reaches a low warning threshold. The voltage under flash load sags briefly but the BMS doesn't flag it as a fault. If recycling time is noticeably longer than it was on a fresh original cell, check resting voltage — a healthy cell at partial charge should read above 3.6V at rest.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBattery percentage jumping in large steps during a shoot\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThe DC-5300 maps battery percentage against a fixed discharge voltage curve stored in the camera firmware. A new replacement cell may discharge along a slightly different voltage curve than the original cell the firmware was calibrated against. This causes the indicator to sit at one level for an extended period then drop several percentage points at once. It is not a fault with the cell itself — it is a threshold mismatch. Running two or three full charge-discharge cycles through the camera body allows the BMS to observe the actual discharge curve and narrows the jump behaviour. After conditioning, resting voltage at \"50%\" displayed should fall between 3.7V and 3.75V.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43333910855770,"sku":"BWCS-NP60FU-1","price":22.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43333910888538,"sku":"BWCS-NP60FU-2","price":25.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43333910921306,"sku":"BWCS-NP60FU-3","price":27.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-NP60FU-1.webp?v=1778213591","url":"https:\/\/batteryweb.com\/products\/maginon-dc-5300-replacement-battery-37v-1050mah-li-ion","provider":"BatteryWeb","version":"1.0","type":"link"}