{"product_id":"maingear-vector-pro-mg-vcp17-replacement-battery-1155v-7800mah-li-polymer","title":"Maingear Vector Pro MG-VCP17 Compatible Battery 11.55V 7800mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eMaingear Vector Pro MG-VCP17 — 11.55V Li-Polymer Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is an 11.55V, 7800mAh (90.09Wh) lithium-polymer replacement battery for the Maingear Vector Pro MG-VCP17 laptop. It replaces the original cell when capacity has dropped and the system can no longer hold a charge away from the AC adapter. Voltage and physical dimensions match the original unit at 287.60 x 97.30 x 9.50mm.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eVector Pro MG-VCP17 fitment:\u003c\/strong\u003e\n    The MG-VCP17 uses a three-cell Li-Polymer pack at a nominal 11.55V rail. This replacement matches that voltage and the physical connector orientation so the BMS handshake completes on first boot without a firmware workaround.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this cell through charge, idle draw, and a sustained CPU-plus-display load cycle. The BMS held the charge curve within spec and did not trigger an unexpected cutoff under peak draw.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003ePost-install calibration on the MG-VCP17:\u003c\/strong\u003e\n    After fitting, run one full discharge until the system hibernates at its low-voltage cutoff, then charge uninterrupted to 100%. This resets the BIOS battery learn cycle and clears the inaccurate health warning the firmware throws after every cell swap.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eWhy the MG-VCP17 BIOS reports poor battery health immediately after a cell swap\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThe Vector Pro stores historical charge data in EEPROM on the battery itself. When a new cell goes in, that EEPROM is blank or carries factory default values that do not match the laptop's learned charge profile. The BIOS reads this mismatch as a fault and flags the battery as degraded or unknown. Running one full discharge-to-hibernate followed by a complete uninterrupted charge gives the firmware enough data to rewrite the learn cycle correctly and clear the warning.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eMG-VCP17 shutting down at 20–30% charge shown on screen\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis symptom points to a voltage cliff in the old cell — under combined CPU and display load, terminal voltage drops faster than the fuel gauge IC tracks it, so the system hits the hardware undervoltage cutoff while the OS still shows charge remaining. A new cell with full capacity eliminates the sag that triggers the early cutoff. After fitting this replacement, run the calibration cycle described above so the fuel gauge IC relearns the actual discharge curve of the new chemistry. If the shutdown persists after two full calibration cycles, check that BIOS is not enforcing a charge-limit profile — navigate to the power settings section and confirm the cutoff threshold is set above 15V on the pack.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43409523212378,"sku":"BWCS-MDX250NB-1","price":122.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43409523245146,"sku":"BWCS-MDX250NB-2","price":141.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43409523277914,"sku":"BWCS-MDX250NB-3","price":154.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-MDX250NB-1.webp?v=1779579941","url":"https:\/\/batteryweb.com\/products\/maingear-vector-pro-mg-vcp17-replacement-battery-1155v-7800mah-li-polymer","provider":"BatteryWeb","version":"1.0","type":"link"}