{"product_id":"pamiel-td-910b-replacement-battery-37v-720mah-li-ion","title":"Pamiel TD-910B Replacement Battery 3.7V 720mAh Li-ion","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003ePamiel TD-910B — 3.7V Li-ion Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 3.7V Li-ion cell rated at 720mAh (2.66Wh), built to fit Kodak digital cameras listed under the TD-910B compatibility group. It replaces the original cell when capacity has faded or the pack no longer holds a charge. Dimensions are 39.50 × 35.40 × 5.60mm — confirm these against your original before ordering.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eTD-910B platform fit:\u003c\/strong\u003e\n    Kodak cameras in this group share the same physical cell envelope, 3.7V nominal rail, and connector orientation. The BMS in these bodies reads cell voltage directly — no proprietary handshake chip is involved, so a correctly sized cell at the right voltage registers without issue.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this cell through charge and discharge on a camera-body load, confirming the BMS accepted the cell, the charge indicator responded correctly, and the protection circuit tripped at the expected low-voltage cutoff.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eFirst-cycle calibration on Kodak bodies:\u003c\/strong\u003e\n    Run the first full charge through the OEM charger or inside the camera body rather than a generic third-party charger. Some Kodak bodies recalibrate the battery-remaining display during the first in-body charge cycle, which sets the voltage thresholds used for the remaining-charge readout.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBattery percentage jumping erratically on a new TD-910B cell\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eKodak cameras in this family map remaining charge by reading cell voltage against a fixed discharge curve stored in the body firmware. A new Li-ion cell has a slightly different voltage profile than an aged original, so the camera's percentage display can skip or jump — especially in the upper and lower 20% of the range. This is a firmware mapping issue, not a cell fault. Run two or three full charge-and-discharge cycles through the camera body; the display typically stabilises as the BMS learns the new cell's response curve. After that, the readout should track smoothly from 100% down to the low-battery cutoff at approximately 3.0V.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eFlash not fully recycling between shots on a new replacement cell\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThe flash capacitor in compact Kodak cameras draws a short, sharp burst of current to recharge between shots. At the end of a cell's life — or with a counterfeit cell that undershoots its rated capacity — internal resistance rises and that recharge current sags, causing the flash to fire at reduced output or take longer to ready. If a new replacement cell still shows this behaviour, check that the cell contacts on both the battery and the body are clean and making full contact. A thin layer of oxidation or debris on the contacts increases effective resistance — clean with a dry cloth and retry before assuming a cell fault.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43333839913050,"sku":"BWCS-KLIC7001-1","price":22.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43333839945818,"sku":"BWCS-KLIC7001-2","price":25.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43333839978586,"sku":"BWCS-KLIC7001-3","price":27.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-KLIC7001-1.webp?v=1778213291","url":"https:\/\/batteryweb.com\/products\/pamiel-td-910b-replacement-battery-37v-720mah-li-ion","provider":"BatteryWeb","version":"1.0","type":"link"}