{"product_id":"samba-replacement-battery-144v-3000mah-ni-mh","title":"Samba YX-NI-MH-022144 Cordless Vacuum Replacement Battery 14.4V 3000mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eSamba YX-NI-MH-022144 — 14.4V Ni-MH Replacement Battery\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 14.4V 3000mAh Ni-MH replacement battery for Samba cordless vacuum cleaners that use part number YX-NI-MH-022144. It matches the original pack's voltage, capacity, and connector format. When the original cell degrades and suction power drops, this unit restores full motor drive voltage.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eSamba cordless vacuum fitment:\u003c\/strong\u003e\n    Samba stick and handheld vacuums in this voltage class run a 14.4V motor bus. The connector and cell count are matched to that bus. Swapping to a different voltage — even 14.8V nominal Li-ion — will trip the motor controller or damage it over time.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We cycled this pack through load and recovery sequences on a 14.4V vacuum motor bench. The BMS held cutoff correctly under high-draw blockage simulation and recovered cleanly after the load was removed. Capacity measured at 2,980mAh on the third discharge cycle.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eDock charging behaviour:\u003c\/strong\u003e\n    Do not leave this vacuum on the charging dock continuously. Ni-MH cells on permanent trickle charge develop capacity fade faster than cells charged only when depleted. Charge to full, then remove from the dock and store the vacuum off the base.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eSuction dropping before the battery indicator reaches low\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis is one of the most misread symptoms on cordless vacuums. Users assume the battery is weak, but the actual cause is usually a partially blocked filter forcing the motor to draw above rated current. At elevated draw, the cell voltage sags early — the indicator never triggers because state-of-charge logic doesn't see a low-voltage condition, just a loaded one. Clean or replace the filter first. If suction recovers immediately, the battery was not the problem. If it doesn't, and the pack voltage reads below 12.5V under load, the cell has degraded.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eMotor cuts out mid-use and then restarts after a short pause\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis is a BMS overcurrent trip, not a dead battery. It happens when sustained suction restriction — a blocked nozzle, a full dust cup, or a clogged filter — pushes motor draw past the pack's current threshold. The BMS disconnects to protect the cells, then resets once current demand drops. Clear the blockage and empty the dust cup before assuming the replacement pack is faulty. If the cutout continues on an unobstructed run, check that the pack voltage holds above 13V at rest; anything lower indicates a cell imbalance in the new pack.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43428047519834,"sku":"BWCS-SBR210VX-1","price":80.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43428047552602,"sku":"BWCS-SBR210VX-2","price":93.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43428047585370,"sku":"BWCS-SBR210VX-3","price":103.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-SBR210VX-1.webp?v=1779933966","url":"https:\/\/batteryweb.com\/products\/samba-replacement-battery-144v-3000mah-ni-mh","provider":"BatteryWeb","version":"1.0","type":"link"}