{"product_id":"sharp-cocorobo-rx-v60-replacement-battery-16v-3000mah-lifepo4","title":"Sharp COCOROBO RX-V60 Compatible Battery 16V 3000mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eSharp COCOROBO RX-V60 \/ RX-V80 \/ RX-V90 \/ RX-V100 — 16V LiFePO4 Replacement Battery (UBATiA001VBKZ)\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 16V LiFePO4 replacement battery for the Sharp COCOROBO robotic vacuum cleaner range. It fits the RX-V60, RX-V80, RX-V90, RX-V100 and six additional COCOROBO variants. Capacity is 3000mAh (48Wh), matching the original specification.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eCOCOROBO series compatibility:\u003c\/strong\u003e\n    The RX-V60 through RX-V100 share the same 16V battery platform and connector format. All run the same BMS handshake, so the UBATiA001VBKZ and cross-referenced part numbers (UBATiA003VBKZ, F-4991-810-1, LIS5003SPP) all apply across this lineup without modification.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this cell through charge and discharge cycles on the COCOROBO platform. The BMS responded correctly to the dock charger's handshake, accepted a full charge without fault codes, and held voltage under sustained drive-motor load on both hard floor and carpet-resistance profiles.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eDock charging discipline:\u003c\/strong\u003e\n    Do not leave the COCOROBO sitting on its dock permanently between cleaning sessions. Continuous trickle charge through the dock accelerates capacity fade in LiFePO4 cells at this form factor. Charge to full, then remove the unit from the dock until the next use.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eSuction dropping before the battery indicator reaches low\u003c\/h3\u003e\n\n  \u003cp class=\"bpw-desc-p\"\u003eThis happens when the drive motor draws more current than rated — usually caused by a partially blocked filter or brush roll restriction. The BMS responds to the elevated draw by reducing cell output voltage before the indicator circuit registers a low-battery event. The vacuum loses suction, but the LED still shows charge remaining. Clear the filter and brush roll first. If suction recovers immediately, the battery is not the cause — the restriction was forcing the motor above its normal draw threshold.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eMotor cuts out mid-cycle and then restarts on its own\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis is a BMS overcurrent trip, not a dead battery. When the COCOROBO transitions from hard floor to carpet, motor load spikes sharply. If the filter is even partially blocked at that moment, current demand exceeds the BMS trip threshold and the cell disconnects to protect itself. The unit then restarts once the BMS resets — typically within a few seconds. Clean the filter until airflow is unrestricted, then confirm the resting pack voltage reads at or above 15.2V before the next run.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43428022779994,"sku":"BWCS-HRX900VX-1","price":104.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43428022812762,"sku":"BWCS-HRX900VX-2","price":123.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43428022845530,"sku":"BWCS-HRX900VX-3","price":137.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-HRX900VX-1.webp?v=1779933901","url":"https:\/\/batteryweb.com\/products\/sharp-cocorobo-rx-v60-replacement-battery-16v-3000mah-lifepo4","provider":"BatteryWeb","version":"1.0","type":"link"}