{"product_id":"sony-dcr-dvd908e-replacement-battery-74v-3300mah-li-ion","title":"Sony NP-FH100 Camcorder Replacement Battery 7.4V 3300mAh","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eSony DCR-DVD908E \/ HDR-HC7E Series — 7.4V Li-ion Replacement Battery (NP-FH100)\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis is a 7.4V, 3300mAh (24.42Wh) Li-ion battery pack built to the NP-FH100 specification. It fits the Sony DCR-DVD908E and over 220 additional Sony Handycam models across the DCR and HDR lines. The InfoLITHIUM communication circuit is retained, so the camera body can report a battery percentage reading rather than a simple charge bar.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eDCR and HDR series compatibility:\u003c\/strong\u003e\n    Models from the DCR-DVD908E, DCR-HC47, HDR-HC7E, and DCR-SR220D all share the same 7.4V InfoLITHIUM bus and the same physical latch geometry — that is why a single NP-FH100 cell spans all of them. The BMS handshake protocol is identical across the group.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this cell through the HDR-HC7E body and monitored BMS communication at the data pin. The pack completed the InfoLITHIUM handshake cleanly, and the camera accepted the percentage reporting without throwing an incompatibility flag.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eDVD-mechanism draw tip:\u003c\/strong\u003e\n    DVD-based Handycams spin a physical disc drive during recording. That motor adds a continuous current draw on top of the sensor and processor load. Avoid pausing and resuming repeatedly in a short session — each disc spin-up pulls a higher current burst than sustained recording does.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eSony BMS authentication check on first install\u003c\/h3\u003e\n\n  \u003cp class=\"bpw-desc-p\"\u003eSony's InfoLITHIUM system checks the data pin on the battery pack before accepting percentage reporting. On a new third-party cell, the camera sometimes displays a low or zero percentage on the very first power-on because the internal calibration table has no history for this cell's discharge curve. Running one full charge cycle through the OEM charger or camera body gives the BMS enough data to map the new cell's voltage curve correctly. After that cycle, the percentage readout stabilises and tracks accurately through normal use.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eBattery percentage jumping erratically mid-recording\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThe DCR-DVD908E estimates remaining charge by mapping current cell voltage against a stored discharge curve. When a replacement cell has a slightly different voltage-to-capacity slope than the original Sony cell, the camera's lookup table returns inconsistent percentage values — particularly between 60% and 30% where the curve flattens. This is a calibration mismatch, not a fault in the cell itself. Run two full charge-discharge cycles and the BMS recalibrates; the readout will stop jumping once the camera has recorded a full discharge profile down to the 7.0V cutoff point.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43333917704282,"sku":"BWCS-FH100D-1","price":39.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43333917737050,"sku":"BWCS-FH100D-2","price":46.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43333917769818,"sku":"BWCS-FH100D-3","price":51.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-FH100D_1.webp?v=1778213576","url":"https:\/\/batteryweb.com\/products\/sony-dcr-dvd908e-replacement-battery-74v-3300mah-li-ion","provider":"BatteryWeb","version":"1.0","type":"link"}