{"product_id":"verathon-glidescope-monitor-replacement-battery-111v-1200mah-li-ion","title":"Verathon GlideScope Monitor 11.1V Replacement Battery 0400-0100","description":"\u003cdiv class=\"bpw-desc\"\u003e\n  \u003ch2 class=\"bpw-desc-h2\"\u003eVerathon GlideScope Monitor — 11.1V Li-ion Replacement Battery (0400-0100)\u003c\/h2\u003e\n\n  \u003cp class=\"bpw-desc-lead\"\u003eThis 11.1V, 1200mAh Li-ion battery replaces the OEM pack in the Verathon GlideScope Monitor and Glidescope Portable GVL Laryngoscope. It fits units referenced under part numbers 0400-0100 and 0800-0404, among others. The GlideScope is a video laryngoscope used in airway management and intubation procedures, so battery readiness directly affects clinical availability.\u003c\/p\u003e\n\n  \u003cul class=\"bpw-desc-bullets\"\u003e\n    \u003cli\u003e\n\u003cstrong\u003eGlideScope monitor and portable GVL compatibility:\u003c\/strong\u003e\n    Both the monitor and portable GVL units run the same 11.1V three-cell Li-ion architecture with a shared BMS handshake protocol. The connector pinout and cell group voltage thresholds match across these variants, which is why one pack covers the full range.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003eBench tested on actual hardware:\u003c\/strong\u003e\n    We ran this pack through charge and load cycles to confirm BMS communication, cell balance across all three groups, and correct voltage reporting to the host device. The protection circuit engaged at expected cutoff voltages under simulated load.\u003c\/li\u003e\n\n    \u003cli\u003e\n\u003cstrong\u003ePower-on self-test handling after swap:\u003c\/strong\u003e\n    After installing this battery, let the GlideScope complete its full boot and self-test sequence without interruption. The device runs a BMS verification routine at startup — cutting power during this step logs a battery fault that persists until the next clean reboot, even if the battery itself is fine.\u003c\/li\u003e\n  \u003c\/ul\u003e\n\n  \u003chr class=\"bpw-desc-divider\"\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eGlideScope not completing boot sequence on a new battery\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eA new Li-ion cell ships at a partial state of charge, and the GlideScope BMS applies stricter voltage thresholds during its boot self-test than it does during normal operation. If the pack voltage reads low against the OEM calibration baseline, the device may stall mid-sequence or refuse to proceed past the self-test screen. Run one full charge cycle before first clinical use — the BMS recalibrates its internal thresholds after the initial cycle completes. A cell sitting at or above 11.4V before boot will clear this reliably.\u003c\/p\u003e\n\n  \u003ch3 class=\"bpw-desc-h3\"\u003eLow battery alarm triggers immediately after confirmed full charge\u003c\/h3\u003e\n  \u003cp class=\"bpw-desc-p\"\u003eThis happens because the GlideScope's charge IC and BMS compare cell impedance against stored OEM benchmarks during the first few cycles. A new cell has slightly higher impedance than a conditioned one, causing the monitor to interpret the pack as degraded even at full voltage. The alarm clears after one to three complete charge-discharge cycles, once the BMS updates its internal state-of-health estimate. Charge fully, run the device through a complete session, then recharge — the threshold recalibrates and the alarm stops triggering.\u003c\/p\u003e\n\u003c\/div\u003e","brand":"BatteryWeb","offers":[{"title":"Warranty 1 Year","offer_id":43381471707226,"sku":"BWCS-VCZ192MD-1","price":40.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 2 Year","offer_id":43381471739994,"sku":"BWCS-VCZ192MD-2","price":47.99,"currency_code":"USD","in_stock":true},{"title":"Warranty 3 Year","offer_id":43381471772762,"sku":"BWCS-VCZ192MD-3","price":52.99,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0674\/4775\/0746\/files\/BW-CS-VCZ192MD-1.webp?v=1778901067","url":"https:\/\/batteryweb.com\/products\/verathon-glidescope-monitor-replacement-battery-111v-1200mah-li-ion","provider":"BatteryWeb","version":"1.0","type":"link"}