Prestigio MultiPhone 4044 Duo Compatible Battery 3.7V 1500mAh

Prestigio MultiPhone 4044 Duo — 3.7V Li-ion Replacement Battery (PAP4044 DUO)

This 3.7V, 1500mAh Li-ion cell is a direct swap for the original battery in the Prestigio MultiPhone 4044 Duo dual-SIM Android smartphone. It fits the PAP4044 DUO platform and restores power to phones that no longer hold a charge or fail to power on. Capacity is 1500mAh (5.55Wh) — matching the original specification exactly.

• MultiPhone 4044 Duo platform fit: The PAP4044 DUO uses a fixed connector pinout and a BMS that expects a 3.7V nominal cell. This replacement matches that voltage rail and connector layout, so the phone's charge IC and fuel gauge IC see the cell correctly on first boot.
• Bench tested on actual hardware: We cycled this cell through a full discharge and charge sequence on a PAP4044 Duo unit. The BMS accepted the cell without lockout, the charge IC ramped normally through CC/CV phases, and the fuel gauge initialised without throwing a fault.
• Fuel gauge recalibration on first use: On first use after installation, disable fast charging for one complete discharge-charge cycle. The fuel gauge IC on this phone was calibrated to the old cell's discharge curve. Running one full cycle at standard charge current lets it recalibrate before high-current charging pushes into an uncalibrated cell model.

Sudden shutdown at 20–30% on the MultiPhone 4044 Duo after a cell swap

This happens because the fuel gauge IC still holds the discharge curve of the old, degraded cell. A fresh cell has a steeper voltage cliff at the low end — the phone reads 25% but the cell voltage is already near the BMS cutoff threshold under modem or screen load. The phone shuts down to protect the cell, even though the percentage shown looks safe. One full discharge-charge cycle on the new cell forces the coulomb counter to resync its model. After that cycle, the percentage readout tracks accurately against the new cell's actual curve.

Phone not powering on after the replacement battery sat in storage

Li-ion cells self-discharge slowly during storage. If this cell arrived at or below 2.5V per cell, the BMS may have entered a lockout state to prevent damage. Do not attempt a normal boot — connect to a wall charger first and leave it for at least 20 minutes before pressing the power button. If the phone still shows no response, confirm the charger is delivering current by checking for any charge LED activity. A locked-out BMS will typically recover once the cell is nudged above 2.9V through the charger's trickle-charge phase.