Minelab Sovereign XS Replacement Battery 11.1V 2600mAh P3-XS

Minelab Sovereign XS — 11.1V Li-ion Replacement Battery (P3-XS)

This 11.1V 2600mAh (28.86Wh) Li-ion battery replaces the original pack in the Minelab Sovereign XS metal detector. It matches the OEM voltage rail and connector configuration for the Sovereign XS platform. Capacity figures are taken directly from the product specification, not estimated from third-party sources.

• Sovereign XS platform fit: The Sovereign XS runs a dedicated 11.1V three-cell Li-ion architecture. This replacement uses the same cell configuration and connector pinout, so the detector's internal charge management circuit communicates with the pack correctly without triggering a pack-rejection fault.
• Bench tested on actual hardware: We cycled this pack through the Sovereign XS power-on sequence and confirmed the BMS held voltage within the detector's operating window across full draw conditions. No cutoff events occurred during standard coil-active operation.
• First-use initialisation on the Sovereign XS: After fitting this pack, run the detector through a full power-on and ground balance cycle before heading into the field. The Sovereign XS maps battery state during that initialisation sequence — skipping it causes the low-battery indicator to trigger early on the first outing, even with a fully charged pack.

Why the Sovereign XS throws a low-battery warning immediately after fitting a new pack

The Sovereign XS monitors battery state against a stored voltage threshold from the previous pack. When you fit a new cell with a different resting voltage curve, the detector compares the new pack's open-circuit voltage against that old reference and flags it as low. This is not a fault with the replacement battery — it is a calibration gap. Running a full ground balance cycle resets the reference and clears the warning. After one complete field session, the indicator tracks accurately.

Sovereign XS powers on but shuts off when the coil begins active sweep

The Sovereign XS coil draws a short current spike the moment it starts actively transmitting. If the battery pack has been in storage and the BMS has entered a low-voltage protection state, that initialisation spike trips the BMS cutoff before the detector reaches stable operation. Measure the pack's resting voltage — if it reads below 9.0V, the BMS needs a recovery charge before normal use. Connect to a compatible Li-ion charger and allow a trickle pre-charge cycle to bring the pack above the 9.0V recovery threshold before attempting to power the detector again.