Easyhome 800560 Robot Vacuum Replacement Battery 14.8V 2600mAh

Easyhome 800560 Robot — 14.8V Li-ion Replacement Battery

This is a 14.8V, 2600mAh Li-ion battery for the Easyhome 800560 robot vacuum cleaner. It powers the drive motors, suction motor, and navigation electronics in that unit. Voltage and capacity match the original cell specification exactly.

• 800560 Robot platform fit: The 800560 shares a single battery architecture across its motor and navigation load. The 14.8V rail feeds both systems from one pack, so the BMS must handle the combined draw without tripping on motor-start surge during direction changes or obstacle navigation.
• Bench tested on actual hardware: We cycled this pack through repeated motor-start loads on the 800560 platform. The BMS held through the inrush current spikes that occur when the drive wheels reverse on thick carpet. No false overcurrent trips were recorded during the test sequence.
• Dock charging discipline on the 800560: Do not leave the 800560 sitting on its charging dock permanently between uses. Robot vacuums on continuous dock charge trickle-charge the Li-ion cells indefinitely, accelerating capacity fade. Charge fully and remove from the dock, or use the unit on a regular schedule to prevent shallow-cycle degradation.

Suction dropping before the battery indicator reaches low on the 800560

The 800560's suction motor draws more current when the filter is partially blocked. As the filter loads up mid-session, the motor pulls above its rated draw, and the BMS steps back the available current to protect the cells. The result looks like a weak battery when the actual cause is restricted airflow forcing an overcurrent condition. Clean or replace the filter first — if suction recovers and holds, the battery was never the issue.

Motor cutting out briefly then recovering during a cleaning cycle

This is a BMS overcurrent trip, not a charge fault. When the 800560 drives over a thick rug or encounters sustained resistance, the combined load from the drive and suction motors can spike above the BMS protection threshold. The BMS cuts output for a moment then resets. Check the filter and brush roll for debris before assuming a battery fault — a blocked brush roll creates the sustained load that triggers this cycle. If trips continue on a clean machine, verify the pack voltage reads at least 16.4V immediately after a full charge.