OPPO Find X7 Ultra BLPA37 Replacement Battery 7.82V 2400mAh

Oppo Find X7 Ultra — 7.82V Li-Polymer Replacement Battery (BLPA37)

This is a 7.82V, 2400mAh Li-Polymer cell built to the BLPA37 spec for the Oppo Find X7 Ultra smartphone. It fits the Find X7 Ultra directly, matching the original connector and BMS handshake. Use it to restore power capacity on a phone where the original cell has degraded through repeated charge cycles.

• Find X7 Ultra fitment: The Find X7 Ultra runs a dual-cell pack configuration behind a fused BMS — this BLPA37 cell matches the voltage rail and connector pinout that the phone's charge IC expects. A mismatched cell voltage causes the charge IC to reject the pack entirely.
• Bench tested on actual hardware: We ran this cell through a full charge cycle and confirmed BMS handshake, charge acceptance at the rated voltage, and discharge curve stability across a load sweep. No cutoff anomalies were recorded.
• Fuel gauge recalibration after swap: On first use after installation, disable fast charging and run one complete discharge-charge cycle at standard speed. This lets the fuel gauge IC map its coulomb counter against the new cell's actual discharge curve before high-current charging applies load to an uncalibrated pack.

Why the Find X7 Ultra reports wrong battery percentage after a cell swap

The Find X7 Ultra uses a coulomb-counter fuel gauge IC that learns the discharge curve of the installed cell over time. When you swap in a new cell, the IC still holds the old cell's curve in memory. It reads voltage correctly but maps it to the wrong state-of-charge model, so displayed percentage drifts — often reading 30% while the cell sits at a higher actual charge. One full slow-speed discharge down to auto-shutdown, followed by a full charge, forces the IC to write a new baseline. After that cycle, percentage accuracy normalises.

Sudden shutdown at 20–25% on the new cell

This happens when the fuel gauge IC is miscalibrated and the phone hits a voltage cliff — the cell voltage drops sharply under modem or display load before the displayed percentage reaches zero. The IC cuts power at roughly 3.0–3.2V per cell to protect the pack, even though the screen still showed charge remaining. Run one full discharge cycle without fast charging to recalibrate the voltage-to-percentage mapping. If shutdowns persist past two full cycles, measure resting cell voltage with a multimeter — it should read above 3.7V at a claimed 50% state of charge.