Wiko U Feel Prime TLP16L08 Replacement Battery 3.8V 2800mAh

Wiko U Feel Prime — 3.8V Li-Polymer Replacement Battery (TLP16L08)

This 3.8V, 2800mAh Li-Polymer cell replaces the TLP16L08 battery in the Wiko U Feel Prime (model 9692). It restores full phone operation — calls, screen, and background app activity — when the original cell has degraded or failed to hold charge. Voltage and capacity match the OEM specification exactly.

• U Feel Prime / 9692 fit: Both model references share the same battery bay dimensions (72.00 × 59.20 × 4.04mm), connector pinout, and BMS handshake. The TLP16L08 part number covers the full production run of this phone.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the U Feel Prime platform. The onboard charge IC accepted the cell without error flags, and the BMS protection circuit triggered correctly at the low-voltage cutoff threshold.
• Fuel gauge recalibration on first cycle: After fitting this cell, disable fast charging and run one full discharge-charge cycle at standard rate. The U Feel Prime's fuel gauge IC is calibrated to the old cell's discharge curve — one full cycle at standard current lets it remap against the new cell before fast charging pushes higher current into an uncalibrated profile.

Sudden shutdown at 20–30% on the U Feel Prime after a cell swap

This is a voltage cliff problem, not a capacity problem. When the modem transmits or the screen peaks in brightness, current draw spikes sharply. A new cell that hasn't been calibrated into the fuel gauge IC can hit a voltage sag the phone interprets as a dead battery — even when charge remains. The fix is one full standard-rate discharge-charge cycle, which lets the coulomb counter re-anchor its low-voltage threshold to the new cell's actual curve. After that cycle, shutdowns at 20–30% typically stop.

U Feel Prime not powering on after the replacement battery sat in storage

Li-Polymer cells self-discharge during storage. If the TLP16L08 cell dropped below approximately 2.5V per cell before installation, the BMS protection circuit locks out to prevent damage — the phone shows nothing when you press the power button. Connect the phone to a wall charger (not a PC port) and leave it for 15–20 minutes without pressing anything. The charge IC will trickle current into the cell until it clears the BMS lockout threshold, after which the phone will boot normally.