Xiaomi 14 Ultra BP51 Compatible Battery 3.86V 4900mAh

Xiaomi 14 Ultra — 3.86V Li-Polymer Replacement Battery (BP51)

This is a 3.86V, 4900mAh (18.91Wh) Li-Polymer replacement battery for the Xiaomi 14 Ultra smartphone. It replaces the original BP51 cell when capacity has degraded to the point where the phone can no longer sustain a full day of normal use. Fits both the 14 Ultra and Mi 14 Ultra variants sharing the BP51 form factor.

• 14 Ultra and Mi 14 Ultra compatibility: Both variants use the same BP51 cell, connector pinout, and BMS handshake with the Xiaomi charge IC. Swapping this cell into either board produces the same voltage rail and thermistor response the system expects.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on a 14 Ultra board. The BMS accepted the cell without fault flags, and the charge IC ramped through CC/CV stages cleanly with no thermal interruptions.
• First-cycle fast charge protocol: On first use after installation, disable Xiaomi's fast charging for one complete discharge-charge cycle. This lets the fuel gauge IC recalibrate its coulomb counter against the new cell's discharge curve before high-current charging pushes into an uncalibrated state.

Sudden shutdown at 20–30% on the replacement cell

A new BP51 cell has a different internal resistance profile than the worn cell the fuel gauge IC was calibrated to. Under the sudden current spike from the Snapdragon platform's modem burst or the display's peak draw, cell voltage drops faster than the IC predicts, triggering a low-voltage protection cutoff before the gauge reaches zero. The phone reads 25% and shuts off — not a fault, just a miscalibrated curve. One full discharge to automatic power-off followed by a complete charge cycle resets the coulomb counter against the actual cell. After that cycle, cutoffs should align correctly with the displayed percentage.

USB-PD or Xiaomi fast charge not recognised on first plug-in after swap

On the first charge after installation, some units show standard 5W charging even when connected to a Xiaomi 67W or 90W adapter. This happens because the charge IC runs a handshake sequence that checks cell voltage and BMS status before unlocking high-current modes — a freshly installed cell at partial charge can cause the IC to hold back. Plug in the supplied or original Xiaomi cable, allow the first charge to complete fully without interruption, and fast charge negotiation will unlock on the next session. Do not use a third-party cable for the first charge cycle.