BLU Studio 5.0 HD Compatible Battery 3.7V 1800mAh C725605220L

BLU Studio 5.0 HD / Y534Q — 3.7V Li-ion Replacement Battery (C725605220L)

This 3.7V 1800mAh Li-ion cell replaces the original battery in the BLU Studio 5.0 HD, Studio 5.0 HD LTE, and Y534Q. It matches the OEM part number C725605220L and fits the same physical footprint at 72.20 × 56.90 × 4.40mm. Capacity listed is 1800mAh — use this figure, not third-party estimates.

• Studio 5.0 HD and LTE compatibility: Both the standard and LTE variants use the same battery bay dimensions, connector pinout, and BMS handshake protocol. The Y534Q shares this same voltage rail, so one cell covers all three model variants without modification.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on BLU Studio hardware. The BMS accepted charge current normally, temperature stayed within spec at the charge IC, and cutoff voltage triggered correctly at the low-voltage threshold.
• Fuel gauge recalibration on first cycle: On first use after installation, run one full discharge down to auto-shutoff, then charge uninterrupted to 100% before normal use. The Studio's fuel gauge IC is calibrated to the old cell's discharge curve — skipping this step causes the percentage counter to read incorrectly for several days.

Why the Studio 5.0 HD reports wrong battery percentage after a cell swap

The fuel gauge IC on the Studio 5.0 HD tracks charge state using a coulomb counter that was calibrated against the original cell's specific discharge curve. When you install a new cell, that stored curve no longer matches the new cell's actual voltage-to-capacity relationship. The IC will read capacity based on old data, so the percentage shown on screen drifts from actual charge state. One full discharge-charge cycle — letting the phone shut itself off at the low-voltage cutoff, then charging to 100% without interruption — resets the counter against the new cell's real curve.

Sudden shutdown at 20–30% remaining on the BLU Studio 5.0 HD

This happens when the cell voltage drops below the modem's or display's minimum operating voltage under load, even though the gauge still shows charge remaining. At 3.7V nominal, the cell can sag sharply under the combined draw of LTE radio, screen backlight, and processor — hitting the BMS's 3.0V cutoff before the gauge reaches 0%. A fresh cell with an uncalibrated coulomb counter amplifies this. Run the recalibration cycle first; if shutdowns continue, check that the battery connector is seated flat with no debris under the contact strip, then confirm resting voltage reads at least 3.6V after a full charge.