Philips AVENT SCD600 Replacement Battery 3.7V 1050mAh

Philips AVENT SCD600 Series — 3.7V Li-ion Replacement Battery (1ICP06/35/54)

This is a 3.7V 1050mAh Li-ion battery for the parent unit of the Philips AVENT SCD600 baby monitor. It fits the SCD600, SCD600/00, SCD600/10, and SCD610 models. When the original cell degrades and the parent unit stops holding charge between charges, this is the direct swap.

• SCD600 and SCD610 parent unit fit: Both models share the same parent unit housing, battery bay dimensions, and 3.7V power rail. The connector pinout and BMS communication protocol are identical across the SCD600/00, SCD600/10, and SCD610 variants, so one cell covers the full range.
• Bench tested on actual hardware: We ran this cell through a full charge cycle on the SCD600 parent unit. The BMS accepted the charge without fault flags, voltage stabilised at 4.18V at top of charge, and the unit powered on cleanly with display and audio active.
• Wireless re-pair after battery swap: The SCD600 parent unit loses its link to the camera unit when power drops completely during a battery change. After fitting this cell, charge the parent unit before powering it on, then run the pairing sequence — hold the link button on both units until the connection LED confirms.

Parent unit not connecting to camera unit after battery swap

The SCD600 stores its wireless pairing data in volatile memory backed by the battery. When the cell is fully removed, that memory clears — the parent unit forgets the camera entirely. This is not a fault with the new battery. Power on both units, navigate to the pairing menu on the parent unit, and hold the sync button on the camera until the connection icon appears on screen.

Night vision drops out shortly after the parent unit powers on

The IR LEDs in the camera unit draw a higher current than the standard video feed. If the parent unit battery is not fully charged after fitting, voltage sag under load can push the unit into a low-power state that reduces IR output. The symptom looks like a camera fault but it is a voltage issue on the parent side. Charge the parent unit to 4.2V before first use — do not run it off the charger until the charge indicator shows full.