Oricom SC910 Baby Monitor Replacement Battery 3.7V 1050mAh

Oricom SC910 / Secure 910 4.3″ Digital Video Baby Monitor — 3.7V Li-ion Replacement Battery

This 3.7V, 1050mAh Li-ion battery replaces the original cell in the Oricom SC910 and Secure 910 parent handset unit. It fits the portable parent unit of the 4.3″ digital video baby monitoring system. The physical dimensions are 52.00 × 32.00 × 5.00mm — confirm these against your existing cell before fitting.

• SC910 and Secure 910 parent unit fit: Both the SC910 and Secure 910 share the same parent handset housing and battery bay, so one cell covers the full Secure 910 range. The 3.7V nominal voltage matches the original charging circuit on the parent unit dock.
• Bench tested on actual hardware: We ran this cell through charge cycles on the SC910 parent unit dock. The BMS accepted the charge handshake without fault flags and cycled cleanly between 3.0V cutoff and 4.2V full charge.
• Re-pair the parent unit after fitting: The SC910 parent unit drops its wireless link to the camera unit when power is fully interrupted. After fitting this battery, you will need to re-pair the parent unit and camera unit using the pairing button on the camera base — do not skip this step or the screen will show no signal.

Parent unit not connecting to camera unit after battery swap

The SC910 stores its wireless pairing data in volatile memory on the parent unit. Removing the battery clears that link completely, so the camera unit and parent unit no longer recognise each other on power-up. This is not a fault with the new battery — it is normal behaviour after any full power loss. Hold the pairing button on the back of the camera unit until the parent screen shows the live feed to restore the connection.

Night vision drops out or shows a dark screen after battery replacement

The SC910 camera's IR LEDs draw more current than the standard video circuit. When the parent unit battery is low — typically below 3.5V under load — the radio link weakens and the camera can switch off IR illumination to reduce draw on its own power supply. If night vision drops immediately after a battery swap, the new cell likely needs a full charge before the radio operates at full transmit power. Charge the parent unit to 4.2V on the dock before the first night-time session.