Blaupunkt Navi GPS DSNA001 Replacement Battery 3.7V 1100mAh

Blaupunkt Navi GPS / TravelPilot Lucca 3.3 — 3.7V Li-ion Replacement Battery (DSNA001)

This is a 3.7V, 1100mAh Li-ion cell replacing part number DSNA001 in the Blaupunkt Navi GPS and TravelPilot Lucca 3.3 portable GPS navigators. It sits in the same footprint as the original — 49.00 x 35.00 x 6.20mm — and connects to the same battery management circuit. Voltage and capacity match the OEM specification exactly.

• Navi GPS and TravelPilot Lucca 3.3 fit: Both units share the DSNA001 cell format — same voltage rail, same connector pinout, same BMS handshake protocol. Swapping between models does not require any adapter or wiring change.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the Blaupunkt GPS platform, confirming BMS communication, charge termination at 4.2V, and correct low-voltage cutoff without false shutdowns.
• First-fix cold start after swap: After fitting this cell, power the unit on outdoors with a clear sky view before driving. Full power removal forces a GPS cold start — the receiver rebuilds its almanac from scratch, which takes 5–10 minutes for the first satellite lock. Subsequent warm starts drop back under a minute once almanac data is cached.

GPS accuracy reduced at low battery on the Navi GPS

When cell voltage drops below roughly 3.5V, the Blaupunkt Navi GPS reduces receiver sensitivity to protect remaining charge. That power-saving step cuts signal gain, which degrades positional accuracy and can cause the track to drift or jump. You may notice the map dot lagging road position by 20–50 metres before any low-battery warning appears on screen. Keeping the cell above 3.6V during active navigation avoids this sensitivity reduction entirely.

Device shuts off without warning before the battery indicator reaches empty

After extended cell degradation, the on-screen battery gauge loses calibration because it was profiled against the original cell's discharge curve. The firmware triggers a hardware cutoff at its internal voltage threshold — typically 3.3V — while the indicator still shows one bar remaining. A fresh cell re-aligns the real voltage with the displayed level. After fitting, run one full charge-to-cutoff cycle so the BMS can re-calibrate its state-of-charge estimate against the new cell's curve.