Huawei E5878 HB544657EBW Compatible Battery 3.8V 1800mAh

Huawei E5878 — 3.8V Li-Polymer Replacement Battery (HB544657EBW)

This is a 3.8V, 1800mAh Li-Polymer battery for the Huawei E5878 portable WiFi hotspot. It replaces part number HB544657EBW directly. Fits the E5878 only — confirm your model before ordering.

• E5878 platform fit: The E5878 runs a combined cellular modem and multi-device WiFi radio from a single 3.8V cell. This battery matches that voltage rail and the connector footprint. The BMS handshake is calibrated to the E5878 charge circuit, so the device reads state-of-charge correctly from the first boot.
• Bench tested on actual hardware: We ran this cell on an E5878 unit with five connected clients and monitored the BMS through a full charge and discharge cycle. Voltage held steady above 3.5V under combined modem and WiFi load, and the protection circuit tripped cleanly at the low-voltage cutoff without false shutdowns.
• Ventilation during extended sessions: Keep the E5878 on a hard, open surface when running long sessions. When connected devices are far from the hotspot, the cellular radio ramps to maximum output power. That extra heat load sits directly on the battery cell — blocking airflow under the device accelerates cell temperature and shortens cycle life.

Why the E5878 disconnects users mid-session under full load

The E5878 draws current from two sources simultaneously — the LTE modem and the WiFi radio. At maximum connected clients, combined draw can spike sharply and pull cell voltage below the BMS trip threshold, triggering a momentary shutdown. An aged or partially degraded cell has higher internal resistance, so voltage sags faster under the same load. A fresh cell at full charge holds the voltage rail above 3.6V through those spikes and keeps the session alive.

E5878 won't power on after sitting unused for weeks

Li-Polymer cells self-discharge slowly in storage. If the E5878 sat unused long enough, the cell voltage may have dropped below the minimum boot threshold — typically around 3.0V for this platform. The device shows no response because the BMS blocks output to protect the cell. Connect the hotspot to its original charger and leave it for 20–30 minutes before attempting to power on; most chargers include a low-voltage recovery trickle mode that brings the cell back above the 3.2V re-initialisation threshold.