Asus Chromebook C425TA Compatible Battery 11.55V 4050mAh

Asus Chromebook C425TA / C433TA — 11.55V Li-Polymer Replacement Battery (C31N1824-1)

This is an 11.55V, 4050mAh (46.78Wh) Li-Polymer battery for the Asus Chromebook C425TA-H50041, C425TA, C433TA, and Chromebook Flip C433TA series. It matches OEM part numbers C31N1824-1, C31PnC1, 0B200-03550000, and 0B200-03550100. Install it when the original cell no longer holds a useful charge or Chrome OS flags battery health as critical.

• C425TA and C433TA series compatibility: Both convertible Chromebook lines share the same three-cell Li-Polymer configuration, 11.55V voltage rail, and C31N1824-1 BMS handshake — so one cell covers the full group without connector or firmware conflicts.
• Bench tested on actual hardware: We cycled this cell on a C425TA chassis. The embedded controller recognised the battery immediately, BMS communication established without error codes, and charge current stepped correctly through CC and CV phases to full capacity.
• Post-install calibration on Chrome OS: After fitting, run the Chromebook down to automatic hibernate cutoff — do not force-shut it — then charge uninterrupted to 100% without using the device. This resets the BIOS battery learn cycle and clears the inaccurate health warning that appears after every cell swap.

Why Chrome OS reports poor battery health immediately after a swap

The Asus embedded controller stores charge cycle count and health data in EEPROM on the battery's protection circuit. When a new cell arrives, that EEPROM carries factory defaults that don't match the host system's learned parameters. Chrome OS reads those values and flags the battery as degraded before a single cycle runs. One full discharge-to-hibernate followed by an uninterrupted charge to 100% forces the learn cycle to overwrite stale EEPROM data with real figures from the new cell.

Chromebook C425TA shutting down at 20–30% charge shown

This happens when the fuel gauge IC hasn't yet calibrated against the new cell's actual voltage curve. The IC inherited calibration data from the old, degraded cell, so it misreads the voltage cliff and triggers a low-battery shutdown well before the cell is empty. Run two to three full discharge-to-hibernate and full-charge cycles without interrupting. After the third cycle the fuel gauge re-maps the curve to the new cell and the shutdown threshold drops back to the correct level near 5–8% charge remaining.