Mipro MB-10 Replacement Battery 14.8V 2600mAh Li-ion

Mipro MA-100su/du & MA-303su/du — 14.8V Li-ion Replacement Battery (MB-10)

This is a 14.8V, 2600mAh (38.48Wh) Li-ion replacement battery for the Mipro MB-10 pack. It fits the MA-100su, MA-100du, MA-303su, MA-303du, and related Mipro wireless portable PA systems. Voltage and cell count match the original four-cell series configuration these amplifiers require.

• MA-100 and MA-303 platform fit: Both model families share the same 14.8V four-cell battery bay, connector pinout, and BMS communication protocol — which is why one MB-10 pack covers both lines. Swapping between these models carries no electrical risk if the voltage matches.
• Bench tested on actual hardware: We ran this pack on an MA-100du at sustained output. The BMS held the discharge curve flat through the mid-range and tripped low-voltage cutoff cleanly without allowing cell sag below the protection threshold. No false shutdowns occurred during the test cycle.
• Monthly discharge cycle for MA-100 users: If the MA-100 lives on a charger between events and rarely drops below 50%, the fuel gauge drifts over time and the speaker may report full charge while actual capacity is significantly lower. Run the battery down below 20% at least once a month before recharging to recalibrate the gauge.

Audio distorting before the battery indicator reaches empty on the MA-100

The MA-100's amplifier stage draws a sharp current spike at high output levels. When the cell voltage sags under that load — even with charge remaining — the amplifier clips before the battery indicator triggers low. This is voltage sag under load, not actual cell failure. The indicator reads state of charge at rest voltage, not under the amplifier's peak draw. If clipping starts at medium volume with bars still showing, check resting voltage at the battery terminals — anything below 13.5V under light load points to a cell that can no longer hold voltage under the amplifier's combined draw.

MA-100 warm to the touch in its carry bag during extended play

The amplifier and battery both generate heat during discharge — the amp through its output stage, the cells through internal resistance. Inside a closed fabric bag, that heat has nowhere to go and stacks. Sustained temperature above 40°C accelerates Li-ion degradation measurably faster than normal use. For events running longer than two hours, pull the MA-100 out of any insulating bag or case and allow airflow around the chassis. If the housing feels hot rather than warm, the battery is discharging under thermal stress — pause playback and let it cool before continuing.