Tronsmart Bang Replacement Battery 7.4V 7800mAh

Tronsmart Bang — 7.4V Li-ion Replacement Battery (INR18650-3S2P)

This is a 7.4V, 7800mAh Li-ion replacement battery for the Tronsmart Bang portable Bluetooth speaker. It slots into the Bang's battery bay to restore wireless operation when the original cell no longer holds a useful charge. Capacity is rated at 57.72Wh, matching the original pack specification.

• Tronsmart Bang compatibility: The Bang runs a 3S2P 18650 cell arrangement to hit the 7.4V nominal rail the amplifier board and Bluetooth module share. Any replacement must match that cell configuration and voltage, otherwise the BMS rejects the pack at handshake.
• Bench tested on actual hardware: We cycled this pack through the Bang's charge controller and monitored BMS communication at full amplifier load. The protection circuit handled current spikes during loud audio playback without tripping the overcurrent cutoff.
• Monthly discharge cycle for the Bang: The Bang is typically used at a desk or on a shelf and topped off constantly. Let the speaker drain below 20% at least once a month before recharging — continuous shallow cycling without a full discharge causes fuel gauge drift and accelerates cell capacity fade over time.

Why the Bang's audio distorts before the battery indicator hits empty

At high volume, the amplifier draws enough current to sag the cell voltage below what the amp needs to drive the speaker cleanly. This happens before the fuel gauge reads zero because the gauge tracks stored charge, not instantaneous voltage under load. The result is audible clipping or distortion while the indicator still shows one or two bars. Keeping the pack above 15% charge under heavy playback avoids the voltage floor where sag-induced distortion starts.

Bang won't wake from USB-C after sitting discharged for weeks

If the Bang is stored without use for several weeks, the cell voltage can drop below the USB-C PD minimum acceptance threshold, and the charge controller won't initiate a charge cycle. The speaker appears completely dead — no LED, no response. Use a USB-A to USB-C cable from a standard 5V charger rather than a PD adapter; the lower-voltage trickle from a basic 5V source often coaxes a deeply discharged Li-ion pack back above the recovery threshold. Once the LED flickers on, switch to the normal charger and complete a full charge cycle before use.