Alcatel One Touch POP 7 TLp032B2 Compatible Battery 3.7V 3200mAh

Alcatel One Touch POP 7 / Pixi 8 — 3.7V Li-Polymer Replacement Battery (TLp032B2)

This 3.7V, 3200mAh Li-Polymer cell replaces the original TLp032B2, TLp032BD, and TLp032C2 batteries. It fits the Alcatel One Touch POP 7, P310A, One Touch Pixi 8, and One Touch Pixi 3 8.0 3G, among other compatible models. If your tablet no longer holds a charge or shuts down unexpectedly, this is the direct cell replacement.

• Shared battery platform across POP 7 and Pixi 8: These tablets run the same 3.7V single-cell Li-Polymer architecture with identical connector pitch and BMS handshake logic, which is why one cell covers the full model group. Voltage regulation and charge termination behave identically across all compatible units.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on a P310A unit. The BMS accepted the charge curve without fault flags, and voltage held steady under combined display and Wi-Fi load without triggering premature cutoff.
• Fuel gauge reset after installation: After fitting this cell, run one full discharge to automatic shutoff, then charge uninterrupted to 100%. This resets the fuel gauge IC calibration against the new cell and clears the inaccurate percentage readings that commonly appear after a swap.

Alcatel POP 7 shutting down at 15–25% remaining

This tablet runs a 7-inch IPS display alongside Wi-Fi and background app activity simultaneously. Under that combined load, voltage drops sharply below a threshold the BMS reads as critically low, even when the percentage gauge still shows 15–25%. The BMS trips a protective cutoff before the gauge catches up. After completing one full calibration cycle on the new cell — full discharge to shutoff, then uninterrupted charge to 100% — the fuel gauge IC re-maps the voltage curve and this false-floor cutoff stops occurring.

Fast charging unavailable after battery swap on One Touch POP 7

Some users find the tablet reverts to standard 5V charging after a battery replacement. The charge IC negotiates the fast-charge protocol on the first accepted charge cycle, not at boot. If you swapped the cell and immediately tested charge speed, the negotiation likely hadn't completed. Plug into the original Alcatel charger, let the tablet charge uninterrupted from under 10% to full, and fast-charge negotiation re-establishes at the correct voltage tier.