DEEBOT 600 Replacement Battery 14.4V 2600mAh 10002265

DEEBOT 600 / 601 / 605 / 710 Series — 14.4V Li-ion Replacement Battery (10002265)

This 14.4V 2600mAh Li-ion battery replaces part number 10002265 in the DEEBOT 600, 601, 605, and 710 robotic vacuum cleaners. It fits directly into the battery bay with the original connector and communicates with the robot's onboard BMS. Capacity is 2600mAh — matching the original cell specification.

• 600-series platform compatibility: The 600, 601, 605, and 710 share the same 14.4V battery architecture, connector pinout, and BMS handshake protocol. One cell covers all four models without adapter or modification.
• Bench tested on actual hardware: We cycled this cell through full charge and discharge on a DEEBOT 600 unit. The BMS accepted the cell without fault codes, current draw stayed within rated limits across hard floor and carpet transitions, and the charge indicator tracked correctly throughout.
• Dock charging habit on robotic vacuums: Do not leave the DEEBOT sitting on the charging dock indefinitely between cleaning sessions. The dock delivers a trickle current when the cell is already full, which accelerates capacity loss in Li-ion cells. Charge to full, then remove from the dock until the next scheduled run.

Suction dropping before the battery indicator reaches low

The DEEBOT 600 motor pulls significantly more current when the filter is partially blocked or the brush roll is tangled. A degraded cell cannot sustain the higher draw, so voltage sags below the motor's operating threshold before the indicator registers low. The robot reduces fan speed to compensate, and suction drops noticeably. Clean the filter and check the brush roll first — if suction recovers immediately, the old battery was masking a restriction issue, not failing on its own.

Robot cuts out mid-clean, then restarts after sitting idle

This is a BMS overcurrent trip, not a power-off event. When suction is restricted — clogged filter, jammed brush, or dense carpet pile — motor current spikes above the BMS threshold and the battery disconnects as a protection response. After a short rest, the BMS resets and the robot powers back on. The fix is to clear the restriction before each run. If cut-outs continue on a clean filter with a new battery, check that cell voltage under load stays above 12V — a reading below that points to a cell fault.