K-Touch T93 Replacement Battery 3.7V 2200mAh Li-ion

K-Touch T93 — 3.7V Li-ion Replacement Battery (T93)

This is a 3.7V, 2200mAh (8.14Wh) Li-ion replacement battery for the K-Touch T93 smartphone. It fits directly into the T93 and restores charging capacity when the original cell has degraded or failed. Dimensions are 75.32 × 59.80 × 4.47mm — verify against your original before installing.

• K-Touch T93 fitment: The T93 uses a fixed connector pinout and BMS handshake tied to this specific cell voltage rail. Swapping to a different capacity or voltage breaks the charge IC communication and prevents the fuel gauge from reading correctly.
• Bench tested on actual hardware: We cycled this cell through full charge and discharge on the T93 platform. The BMS accepted the charge IC handshake on the first cycle, and coulomb counter registration was confirmed before the cell shipped.
• Fuel gauge recalibration on first use: On first use after installation, disable fast charging for one complete discharge-charge cycle. This lets the fuel gauge IC map its calibration curve against the new cell before high-current charging pushes current into an uncalibrated counter — preventing erratic percentage readings.

Sudden shutdown at 20–30% on the T93 after a cell swap

This happens because the fuel gauge IC is still running the discharge curve from the old, degraded cell. The new cell hits a voltage cliff under modem or screen load that the old curve did not predict. The phone interprets this as a valid operating voltage right up until the cell can no longer sustain it under draw. One full discharge-charge cycle lets the coulomb counter relearn the actual curve of the new cell — after that, shutdowns at 20–30% stop.

T93 not powering on after the replacement cell sat in storage

If the cell dropped below approximately 2.5V during storage, the BMS enters a lockout state to prevent damage — the phone will show no response to the power button or charger. Connect the phone to a wall charger rather than a USB port and leave it for 15–20 minutes without touching the power button. The charge IC on most T93 units will trickle current into the cell until it recovers above the BMS re-enable threshold of around 3.0V. If the charging LED does not activate within 30 minutes, the cell voltage may be too low to recover — check with a multimeter across the battery terminals before assuming a fault elsewhere.