Nordmende Nordcam 01 Compatible Battery 3.7V 1120mAh Li-ion

Nordmende Nordcam 01 / Nordcam Sport — 3.7V Li-ion Replacement Battery

This 3.7V 1120mAh Li-ion battery replaces the original cell in the Nordmende Nordcam 01 and Nordcam Sport digital cameras. It matches the OEM voltage and capacity rating, restoring full shooting capability. Dimensions are 44.90 × 32.17 × 7.85mm — physically identical to the factory cell.

• Nordcam 01 and Nordcam Sport compatibility: Both models run the same 3.7V single-cell power rail with an identical physical bay and connector orientation. One replacement cell covers both cameras — no adapter or modification needed.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the bench, monitoring the BMS handshake. The protection circuit engaged correctly at low-voltage cutoff and the camera body accepted the cell without error flags on repeated power cycles.
• First-cycle calibration on the Nordcam: Before heavy shooting, run one full charge cycle inside the Nordcam body using the OEM charger or USB input. Some Nordcam units require an in-body charge cycle to initialise the battery-remaining indicator correctly on a new cell.

Battery percentage jumping on the Nordcam display after fitting a new cell

The Nordcam maps its battery indicator to a set of voltage thresholds calibrated against the original cell's discharge curve. A fresh replacement cell has a slightly flatter discharge curve until it beds in, which causes the indicator to jump between readings. This is a calibration drift in the camera's fuel gauge — not a fault in the replacement cell. Run two full charge-discharge cycles in the camera body and the indicator will track the new cell's curve accurately.

Flash not fully recycling between shots near the end of a charge

As the cell voltage drops toward 3.4V, the current available to recharge the flash capacitor reduces. The Nordcam's flash circuit draws a brief high-current burst to reload the capacitor — at low state of charge, that burst sags the cell voltage enough to slow recycling noticeably. The camera may also reduce flash output automatically to compensate. Charge the battery when the indicator reaches one bar to keep flash recycling at full speed.