Oppo Realme X2 Pro BLP749 Replacement Battery 7.7V 1950mAh

Oppo Realme X2 Pro — 7.7V Li-Polymer Replacement Battery (BLP749)

This is a 7.7V, 1950mAh Li-Polymer replacement cell for the Realme X2 Pro (RMX1931) smartphone. It replaces part number BLP749 when the original cell has degraded from repeated charge cycles. The battery restores power to the processor, display, and all integrated functions.

• RMX1931 fit: The Realme X2 Pro runs a dual-cell Li-Polymer pack under part number BLP749. Both cells share the same connector and BMS handshake, so this replacement matches the required voltage rails and communication protocol for the charge IC.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the RMX1931 platform. The BMS accepted the cell, fast charge negotiation completed after the first full cycle, and the fuel gauge IC locked onto the new discharge curve without error flags.
• Fuel gauge recalibration on first use: After installation, disable fast charging and run one complete discharge-charge cycle at standard rate. This lets the fuel gauge IC map the new cell's discharge curve before high-current fast charging pushes current into an uncalibrated cell.

Sudden shutdown at 20–30% on the replacement cell

The Realme X2 Pro shuts down unexpectedly in the 20–30% range when the fuel gauge IC is still calibrated to the old cell's discharge curve. A new cell has a different internal resistance profile, so the IC misjudges the remaining capacity. Under modem or display load, the cell voltage drops below the BMS cutoff threshold before the percentage reaches zero. One full slow discharge-charge cycle resets the coulomb counter and corrects this behaviour.

VOOC fast charge not activating after cell replacement

The X2 Pro uses Oppo's VOOC protocol, which requires a BMS handshake before elevated current is allowed. On the first cycle with a new cell, the charge IC defaults to standard 5V/2A until it completes a full charge cycle and validates the cell parameters. Forcing fast charge before calibration is complete can result in the adapter falling back to standard rate and staying there. Complete one full standard-rate charge first, then reconnect the VOOC adapter — the protocol handshake should complete normally.