Tineco Floor One Booster Pro 25.2V Replacement Battery 3900mAh

Tineco Floor One Booster Pro — 25.2V Li-ion Replacement Battery (CL2123-7S1P-02B)

This 25.2V 3900mAh Li-ion battery replaces part number CL2123-7S1P-02B in the Tineco Floor One Booster Pro wet-dry cordless floor cleaner. It also fits the FW200100CN, 3.0Plus, 3.0LED, and 3.0LCD models within the same platform. Voltage and BMS communication match the original specification exactly.

• Floor One platform compatibility: The Booster Pro, 3.0Plus, 3.0LED, and 3.0LCD share the same 25.2V seven-cell architecture and battery connector. The BMS on each model communicates over the same data line, so one battery pack covers the full range without modification.
• Bench tested on actual hardware: We ran this pack through full charge and discharge cycles on the Floor One platform, confirming the BMS handshake initialised correctly, the charge light progressed through all stages, and thermal cutoff triggered within spec under a blocked-nozzle load test.
• Dock charging on the Floor One series: Do not leave the vacuum on the dock permanently after a full charge. The Tineco charging dock continues to trickle charge when the unit is seated, and sustained trickle input accelerates cell degradation. Charge to full, then remove the unit from the dock.

Suction dropping before the battery indicator reaches low

The Floor One Booster Pro draws significantly more current when the roller brush or filter is partially blocked. Under that elevated load, cell voltage sags earlier than the indicator predicts — the indicator reads state-of-charge at rest, not under load. The result is reduced suction or automatic power reduction while the LED still shows two or three bars. Clean the filter and check the roller brush for hair wrap before assuming the battery is at fault. A clean filter typically restores full suction output through the majority of the charge cycle.

Motor cuts out briefly then restarts during a cleaning run

This is a BMS overcurrent trip, not a battery fault. When suction is restricted — blocked nozzle, compacted filter, or a large debris piece lodging in the airway — the motor draws more than the BMS overcurrent threshold, which cuts power to protect the cells. The BMS resets within a few seconds and power returns. Clear the blockage first, then check that the filter has been rinsed and fully dried before reinserting. If the cutout continues on a clear airway, check that the replacement pack voltage reads at least 24.5V on a multimeter after a full charge.