Verathon 0400-0066 BladderScan 9400 11.1V Replacement Battery

Verathon BladderScan 9400 / BVI 9400 — 11.1V Li-ion Replacement Battery (0400-0066)

This 11.1V, 5000mAh (55.5Wh) lithium-ion battery replaces OEM part numbers 0400-0066, 0400-0121, and 0570-0066 in the Verathon BladderScan 9400 and BVI 9400 portable ultrasound units. These devices are used in hospitals, clinics, and care facilities for non-invasive bladder volume measurement. The battery matches the OEM voltage rail and connector spec exactly.

• BladderScan 9400 and BVI 9400 compatibility: Both models share the same 11.1V three-cell Li-ion pack architecture, connector pinout, and BMS communication protocol — which is why the same OEM part number covers both units. Swapping between them is a direct electrical match.
• Bench tested on actual hardware: We ran this cell through full charge and discharge cycles on the BladderScan platform. The BMS handshake cleared on first boot, the charge IC accepted the pack without fault, and the unit completed its power-on self-test without interruption.
• Post-installation self-test protocol: After fitting this battery, let the device complete its full power-on self-test cycle before use. Medical devices run BMS verification at startup — cutting power during this sequence triggers a false battery fault that can persist until the next clean reboot.

BladderScan 9400 not completing boot sequence on new battery

The 9400's boot sequence includes an active BMS verification step that checks cell voltage, internal resistance, and chemistry signature before allowing the unit to reach the scan-ready state. A new cell that has partially self-discharged in storage can present a voltage reading just below the BMS acceptance threshold, causing the boot to stall or loop. This is not a faulty battery — it is the device's firmware rejecting an unverified pack. Charge the battery to full on the OEM charger first, then reinsert and allow the boot sequence to run without interruption.

Charge indicator stuck below 100% on first charge after swap

The BladderScan charge IC applies a conservative current limit when it first encounters a new cell, treating it as uncharacterised until one full charge-discharge cycle is logged. This means the indicator may plateau at 90–95% and stop climbing on the initial charge. Run one complete charge-discharge cycle — charge to termination, use the device until low-battery warning activates, then recharge fully. After that cycle, the charge IC recalibrates its endpoint and the indicator will reach 100% on subsequent charges.