VSN Mobil V.360° Compatible Battery LC18350-3P 3.7V 2600mAh

VSN Mobil V.360° / V.360 HD — 3.7V Li-ion Replacement Battery (LC18350-3P)

This is a 3.7V, 2600mAh (9.62Wh) Li-ion replacement cell for the VSN Mobil V.360° and V.360 HD panoramic cameras. It matches the OEM LC18350-3P specification and fits the original battery compartment without modification. Use it to replace a degraded original cell or keep a spare on hand during extended 360° capture sessions.

• V.360° and V.360 HD compatibility: Both models run the same voltage rail, battery compartment dimensions, and LC18350-3P cell format — the connector pinout and BMS handshake are identical across both, so one part number covers both camera variants.
• Bench tested on actual hardware: We cycled this cell through the V.360° body and confirmed the BMS accepted the cell after one full charge via the OEM charger. Thermal performance stayed within normal range across continuous 360° recording draws.
• First-cycle initialisation for V.360° body: Run the first charge entirely through the camera body or OEM charger — not a third-party USB adapter. The V.360°'s BMS maps its battery-remaining display against a charge curve it reads during that initial cycle. Skipping this step often causes erratic percentage readouts from the start.

Battery percentage jumping or reading 100% then dropping suddenly on the V.360°

The V.360°'s fuel gauge maps percentage thresholds against the original cell's discharge curve. A new LC18350-3P cell has a slightly different resting voltage profile at partial states of charge, which throws the indicator off until the BMS recalibrates. Run one full discharge-to-cutoff cycle followed by a full charge through the camera body. After that cycle, the BMS re-maps its thresholds to the new cell and the percentage display stabilises. If it still jumps after two full cycles, check that the cell is seated flush — a loose contact causes voltage noise the BMS misreads.

V.360° body not recognising replacement cell on first install

Some V.360° units run a BMS authentication check on every new cell insertion and will show a no-battery or incompatible indicator if the cell voltage is below their acceptance threshold — typically under 3.5V. Pull the battery, charge it externally to at least 3.6V using the OEM charger, then reinsert. If the camera still rejects it, power-cycle the body twice with the cell seated before retrying. Most units accept the LC18350-3P cleanly once the resting voltage clears 3.6V on first presentation.