Urovo CT48 Replacement Battery HB50DT48 3.85V 4100mAh

Urovo CT48 — 3.85V Li-ion Replacement Battery (HB50DT48)

This is a 3.85V, 4100mAh Li-ion battery for the Urovo CT48 mobile data terminal. It fits CT48 units used in warehouse picking, retail stocktaking, and logistics scanning. The HB50DT48 part number matches the OEM connector and BMS handshake the CT48 expects.

• CT48 platform fit: The CT48 uses a dedicated battery bay with a multi-pin connector that carries both charge and BMS communication. This pack matches that pinout exactly — the device firmware reads cell state correctly and does not flag a foreign-battery warning.
• Bench tested on actual hardware: We ran this pack through charge and discharge cycles on the CT48 platform. The BMS reported accurate state-of-charge, the over-discharge cutoff triggered at the correct threshold, and the pack resumed charging normally in the cradle after cutoff.
• First-shift preparation for pick-and-pack: Before putting this pack into active scanning, seat it in the charging cradle and let it complete a full charge cycle. The scan trigger inrush current peaks when the cell is near minimum — a fully charged pack prevents false BMS trips during the first burst-scan session of the shift.

Why the CT48 cradle shows a charging error on a new pack

Charging errors on a new pack are almost always a contact resistance issue, not a fault with the cell itself. The CT48 cradle reads authentication data through the battery contacts — if those contacts are dirty or the pack is not fully seated, the handshake fails and the dock reports an error. Wipe the gold contacts on both the pack and the cradle with a dry cloth, then press the pack firmly into the dock until it clicks. If the error clears within 30 seconds, contact resistance was the cause.

CT48 losing wireless connection during rapid scan bursts

The CT48 draws simultaneously from its wireless radio and its imager during a rapid scan burst — the combined inrush can cause a momentary voltage sag on a partially discharged cell. When the cell voltage dips below the BMS threshold, the device drops the wireless connection to protect the cell, even though the scanner appears otherwise functional. This is more common when the battery is below 30% charge and scan frequency is high. Keep the pack above 40% during intensive burst-scan workflows to avoid the sag threshold.