Razer Blade 15 Base RC30-0351 Compatible Battery 15.2V 4000mAh

Razer Blade 15 Base — 15.2V Li-Polymer Replacement Battery (RC30-0351)

This is a 15.2V, 4000mAh (60.8Wh) lithium-polymer replacement battery for the Razer Blade 15 Base laptop. It fits models listed under RZ09-0369x. Install it when the original cell no longer holds charge and the laptop won't run untethered from AC power.

• Blade 15 Base and RZ09-0369x compatibility: These models share the same 15.2V four-cell Li-Polymer architecture, identical connector pinout, and the same BMS communication protocol over the SMBus line. A single cell fits all variants in this group without modification.
• Bench tested on actual hardware: We ran this cell through charge and discharge cycles on a Blade 15 Base unit. The BMS negotiated charge termination correctly at full capacity, and the SMBus handshake confirmed cell recognition without error flags in the firmware.
• Post-install recalibration cycle: After fitting this battery, run the laptop on battery power down to automatic hibernate cutoff — do not force shutdown. Then charge uninterrupted to 100%. This resets the BIOS battery learn cycle and clears the inaccurate health warning that appears after every cell swap.

Why the Blade 15 Base shuts down at 20–30% after a battery swap

The Blade 15 Base draws hard on the battery when the CPU and GPU boost simultaneously under gaming load. A new cell's EEPROM carries no discharge history, so the fuel gauge IC has no learned model of the cell's voltage curve. The system firmware sees the voltage drop under load and interprets it as a critically low charge state, triggering shutdown even when the indicated percentage reads 20–30%. Running two full discharge-to-hibernate and full-charge cycles gives the fuel gauge IC enough data to map the new cell's actual voltage profile.

BIOS reporting battery health as "poor" or "replace" immediately after installation

This is an EEPROM mismatch, not a fault with the replacement cell. The old battery wrote its degradation data and cycle count to the system's battery health registers, and those values persist after a swap. The BIOS reads stale data from its own stored record rather than pulling fresh readings from the new cell. Run the Razer Synapse battery calibration tool, or complete one full discharge-to-hibernate cycle followed by a full uninterrupted charge — the health warning clears once the learn cycle writes new baseline data at 100%.