Agfa Optima 147 APB-50 Replacement Battery 3.7V 800mAh

Agfa Optima 147 — 3.7V Li-ion Replacement Battery (APB-50)

This is a 3.7V, 800mAh Li-ion cell for the Agfa Optima 147 compact 35mm film camera. It powers the light meter, autofocus motor, and flash charging circuit. When the original cell depletes, these three systems fail together — this battery restores all of them.

• Optima 147 system fit: The Optima 147 draws from a single cell to run its metering, AF drive, and flash capacitor. The APB-50 footprint — 40.12 × 34.00 × 6.72mm — matches the battery bay contact pitch exactly, so the camera's power rails pick up full voltage without modification.
• Bench tested on actual hardware: We ran this cell through the Optima 147's charge circuit and confirmed the BMS accepted the cell on first install. Flash recycling current and light meter draw both registered within normal operating range across a full discharge cycle.
• Flash capacitor tip for the Optima 147: After fitting a fresh cell, fire the flash manually once before shooting. The capacitor recharge on a fully discharged circuit can pull a brief high-current spike — letting it cycle once conditions the draw before you rely on flash for a shot.

Flash output dropping mid-shoot on a new Optima 147 battery

The Optima 147's flash capacitor pulls a sharp recharge current after each pop. As cell voltage sags toward the lower end of its discharge curve, the capacitor takes longer to top up. The camera doesn't flag this — you just notice softer flash output or a slower ready indicator. If this starts early in a session, check cell voltage at the contacts: below 3.5V under load, the flash circuit is already starved.

Battery percentage jumping erratically on the Optima 147 display

The Optima 147's fuel gauge maps voltage thresholds against its original cell's discharge curve. A new Li-ion cell has a slightly flatter mid-range curve, which can confuse the indicator — the display may jump from full to half without warning. This is a mapping mismatch, not a fault in the cell. Run one full charge-to-discharge cycle through the camera body and the indicator will recalibrate to the new cell's actual curve.