Coppernic C-One e-ID Barcode Scanner Replacement Battery 3.7V 3000mAh BP13-001080

Coppernic C-One e-ID — 3.7V Li-ion Replacement Battery (BP13-001080)

This 3.7V 3000mAh Li-ion battery replaces the original pack in the Coppernic C-One e-ID handheld scanner. It fits both the C-One e-ID and XGK-C-ONE-E-ID variants and cross-references OEM part numbers BP13-001080, E00913001, and PCT3200. At 11.1Wh it matches the original energy rating, so charging behaviour in the cradle stays consistent.

• C-One e-ID and XGK-C-ONE-E-ID fit: Both units share the same physical housing, contact layout, and BMS handshake protocol — one cell fits both without modification.
• Bench tested on actual hardware: We cycled this pack through repeated scan-burst sequences and wireless polling loads. The BMS held cell voltage above the low-voltage cutoff threshold throughout sustained draw, with no false trips during back-to-back trigger events.
• First-shift preparation for pick-and-pack: Before using this battery in a live shift, seat it in the cradle and complete a full charge cycle. The scan trigger inrush current peaks when the cell is near minimum — starting from a full charge prevents the BMS from tripping on the first burst of rapid scans.

Cradle charging error after fitting a new pack

The C-One e-ID cradle reads pack state through spring-loaded dock contacts on the base of the unit. Oxidation or debris on those contacts raises resistance enough for the dock to report a charging fault even when the pack itself is fine. Wipe the gold contacts on the battery and the cradle pins with a dry cloth, then reseat the scanner firmly until it clicks. If the error clears, the pack is charging — confirm with the charge indicator LED turning solid.

Scanner losing wireless connection during rapid scan bursts

During a rapid scan burst the imager and the wireless radio draw simultaneously, creating a combined inrush spike that a degraded or partially charged cell cannot sustain without a voltage sag. When cell voltage dips briefly below the radio module's minimum operating threshold, the wireless stack drops and reconnects — appearing as a connection loss rather than a battery fault. This is most common in the first hour of a shift if the battery was not fully charged before use. Start each shift from a full charge and the combined draw stays within the cell's delivery curve.