Emporia RL1 AK-RL1 Compatible Battery 3.7V 800mAh

Emporia RL1 / VF1C — 3.7V Li-ion Replacement Battery (AK-RL1)

This 3.7V 800mAh lithium-ion cell replaces the original AK-RL1 battery in the Emporia RL1 and VF1C smartphones. It restores power to phones where the original cell has degraded, stopped charging, or dropped below usable capacity. Voltage and connector match the stock configuration — no modification needed.

• RL1 and VF1C compatibility: Both models run on the same 3.7V single-cell architecture with an identical footprint (55.10 × 30.40 × 5.00mm) and share the AK-RL1 part number. The BMS interface and connector pinout are common across both variants.
• Bench tested on actual hardware: We cycled this cell through charge and discharge on the RL1 platform. The BMS accepted the new cell without rejection flags, and charge termination triggered cleanly at full capacity with no thermal events.
• Fuel gauge recalibration on first use: After installing this cell, disable any fast charge option and run one complete discharge-to-charge cycle before normal use. The fuel gauge IC calibrates its coulomb counter against the new cell's discharge curve — skipping this step causes the percentage display to read inaccurately for several days.

Why the Emporia RL1 reports wrong battery percentage after a cell swap

The RL1's fuel gauge IC builds its charge estimate from the previous cell's discharge curve, stored across charge cycles. When a new cell goes in, that stored curve no longer matches the actual cell behaviour. The gauge reads voltage at rest and maps it against the old model, producing readings that are often 10–20% off. One full discharge to automatic shutdown followed by a complete charge to 4.20V resets the counter and brings the display back in line.

Sudden shutdown at 20–30% remaining on the new cell

This is a voltage cliff failure — not a capacity problem. At 20–30% state of charge, the cell voltage under modem or screen load drops sharply below the BMS cutoff threshold, triggering an immediate shutdown even though the displayed percentage suggests charge remains. A fresh or lightly used cell has a steeper voltage curve at low charge than an aged cell, so the fuel gauge hasn't learned where the cliff sits yet. Run two full discharge cycles and the gauge IC will map the cliff point accurately, stopping the early shutdowns.