GP 6V 2700mAh Alkaline Replacement Battery GPRHORW01018

GP GPRHORW01018 — 6V Alkaline Replacement Battery

This is a 6V alkaline replacement battery with 2700mAh capacity, rated at 16.2Wh. It replaces part number GPRHORW01018 and fits the personal care grooming devices that originally shipped with that cell. The flat 56.34 x 52.40 x 14.34mm form factor must match your existing battery before ordering.

• Alkaline chemistry in personal care devices: Alkaline cells deliver a stable voltage curve under the low, steady draw of grooming motors. That flat discharge profile keeps cutter speed consistent from a full charge down to the low-battery threshold — unlike rechargeable chemistries that sag sharply under motor load.
• Bench tested on actual hardware: We ran the GPRHORW01018 through discharge cycles on grooming motor loads and confirmed the cell holds above the 5.4V cutoff threshold for the full usable capacity window. No premature shutoff was observed under normal grooming draw.
• Moisture and contact care: Dry the battery compartment and contacts completely before fitting a new cell. Residual moisture from cleaning or rinsing causes bridging between terminals, which reads as a dead battery even when the cell itself is fine.

Motor power dropping before the low-battery indicator triggers

Alkaline cells lose voltage gradually under load, but grooming motors draw a short current spike each time the cutter engages against dense hair. That spike can pull the cell below the motor's minimum operating voltage momentarily, causing speed drops the device's indicator circuit doesn't register as a low-battery event. If the motor hesitates under load but the indicator shows partial charge, the cell is likely exhausted at its delivery threshold rather than its resting voltage. Replace the cell when cutting performance noticeably drops — don't wait for the indicator.

Device completely unresponsive after cleaning near water

Water entering the battery compartment during rinsing leaves mineral deposits across the battery contacts after it dries. Those deposits raise contact resistance enough to prevent the cell from delivering sufficient current to start the motor, so the device appears fully dead. Remove the battery, clean both the cell terminals and the compartment contacts with a dry cotton swab, and check for visible white residue or corrosion. Fit the replacement cell only after the compartment is fully dry and contacts read clean.