Nikon EN-EL14 Coolpix P7000 Replacement Battery 7.4V 900mAh

NiKon Coolpix P7000 Series — 7.4V Li-ion Replacement Battery (EN-EL14)

This 7.4V, 900mAh Li-ion cell replaces the EN-EL14 battery in the NiKon Coolpix P7000, P7100, P7700, and P7800, plus 33 additional compatible models. It slots into the same battery compartment as the original and connects via the same three-contact interface. Voltage and capacity match the OEM spec exactly.

• Coolpix P7000 series compatibility: These four camera bodies share the same battery bay dimensions, contact layout, and BMS handshake protocol. One cell covers the full lineup without modification.
• Bench tested on actual hardware: We cycled this cell through the P7000 body and a compatible OEM charger. The BMS accepted the cell without fault codes, and charge termination triggered correctly at 8.4V across multiple cycles.
• First-cycle charge protocol for P7000 owners: Charge the new cell fully inside the camera body before shooting. The P7000's battery management system maps remaining capacity against a stored discharge curve — charging in-body on the first cycle gives the indicator accurate reference data for subsequent readings.

Flash recycling lag on the P7000 with a new replacement cell

The P7000's built-in flash draws a sharp burst of current to recharge its capacitor between shots. A replacement cell that hasn't completed its first full charge cycle can show elevated internal resistance, which slows that capacitor recharge. The result is a longer-than-expected pause between flash-enabled shots. Run one full charge-discharge cycle in-camera before flash-heavy shooting and the recycling interval returns to normal.

Battery percentage jumping or reading 100% then dropping suddenly

The P7000 maps its fuel gauge against a fixed discharge curve calibrated to the original EN-EL14 cell. A fresh replacement cell has a slightly different voltage response at each charge state, so the indicator can jump — showing full, then dropping several bars without warning. This is a calibration gap, not a fault with the cell itself. Run two or three full charge-discharge cycles in-camera and the indicator will track the new cell's actual discharge curve accurately.