Philips FISIO 120 Compatible Battery 3.7V 600mAh Li-ion

Philips FISIO 120 / FISIO 121 / P120 — 3.7V Li-ion Replacement Battery

This is a 3.7V, 600mAh Li-ion cell sized to fit the Philips FISIO 120, FISIO 121, and P120 mobile phones. It slots into the same battery bay as the original and connects to the device's charge and protection circuitry. Capacity is 600mAh (2.22Wh), matching the stock specification.

• FISIO 120 / 121 / P120 platform fit: These three models share the same battery bay dimensions and connector pinout, which is why one cell covers all three. The voltage rail and BMS communication lines are identical across the platform.
• Bench tested on actual hardware: We cycled this cell through charge and full discharge on the FISIO platform. The BMS accepted the cell without rejection flags, and the protection circuit tripped correctly at the low-voltage cutoff threshold.
• Fuel gauge recalibration on first use: After fitting this cell, let the phone discharge fully to auto-shutdown, then charge uninterrupted to 100% before normal use. The fuel gauge IC on these handsets calibrates its coulomb counter against a complete cycle — skipping this step causes the percentage display to read inaccurately for weeks.

Sudden shutdown at 20–30% on the FISIO 120 after a cell swap

This is a voltage-cliff failure, not a capacity problem. At around 3.6–3.65V under load — typically during a call or screen-on burst — the new cell briefly sags below the modem's minimum operating voltage, and the phone cuts out even though the gauge still shows charge remaining. The fuel gauge IC hasn't yet mapped the new cell's discharge curve, so its voltage-to-percentage translation is off. One full discharge-charge cycle forces the IC to relearn the curve and shifts the reported shutdown point to match the actual empty threshold.

Phone not powering on after the replacement cell sat in storage

Li-ion cells self-discharge in storage, and if this battery sat long enough to drop below approximately 2.5V per cell, the BMS enters lockout mode to prevent reverse charging damage. The phone won't respond to the power button and may not show a charging indicator immediately when plugged in. Leave the phone connected to a charger for 15–30 minutes without touching it — the charge IC will trickle current into the cell at a safe rate until voltage rises above the BMS re-enable threshold. Once the cell clears roughly 2.8V, normal charging resumes and the phone will boot.