Premier Magic 110 Cordless Phone Replacement Battery 2.4V 600mAh

Premier Magic 110 / 120 / 130 / 210 — 2.4V Ni-MH Replacement Battery

This is a 2.4V, 600mAh Ni-MH rechargeable battery for Premier Magic series cordless phone handsets. It fits the Magic 110, Magic 120, Magic 130, and Magic 210, plus six additional Magic series models. If your handset no longer holds a charge between calls or drops off the base after a short time, this pack replaces the original cell directly.

• Magic series handset compatibility: These Magic series models share the same 2.4V two-cell Ni-MH pack format, physical dimensions (45 × 21 × 10mm), and connector orientation. One SKU covers the full range without modification.
• Bench tested on actual hardware: We cycled this pack through charge and discharge on a Magic 110 handset. The base station accepted the charge handshake on the first placement, and the BMS held voltage within the expected Ni-MH discharge curve across the first three conditioning cycles.
• First-charge protocol for Ni-MH handsets: After installing this battery, seat the handset in the base and leave it undisturbed for a full 16 hours before first use. Ni-MH cells in cordless phones reach rated capacity only after a slow, uninterrupted initial charge — pulling the handset too early limits the maximum charge the pack will accept in future cycles.

Talk time shorter than the original battery after replacement

Ni-MH cells ship in a partially discharged state and do not reach rated capacity on cycle one. The first three to five charge-discharge cycles are conditioning cycles — each one builds on the last. If talk time feels short in the first week, that is expected behaviour, not a fault. By cycle five, the pack should be delivering close to its rated 600mAh capacity.

Base station showing no-charge or error light after battery swap

Ni-MH packs can drop below 2.0V during storage, and some Premier base stations will not initiate a charge cycle if the incoming voltage reads too low. Remove the handset from the base, wait 10 seconds, then reseat it firmly — this resets the charge detection circuit. If the error persists, check that the handset contacts are clean and fully touching the base pins. A short manual trickle from a compatible Ni-MH charger at 60mA for 30 minutes can bring the pack above the base acceptance threshold.