Samsung Galaxy J6 EB-BJ800ABE Replacement Battery 3.85V

Samsung Galaxy J6 SM-J600 Series — 3.85V Li-Polymer Replacement Battery (EB-BJ800ABE)

This is a 3.85V, 3000mAh lithium-polymer replacement battery for the Samsung Galaxy J6 lineup, including SM-J600L, SM-J600N, SM-J600F, and SM-J600FN among others. It carries OEM part numbers EB-BJ800ABE and GH82-16479A. It slots into the standard mid-frame bay and connects to the charge IC via the original five-pin flex connector.

• SM-J600 series fit: All SM-J600 variants share the same battery bay dimensions, connector pinout, and BMS handshake protocol — that is why a single cell covers the full range. The 88.20 × 39.55 × 4.84mm form factor is identical across the lineup.
• Bench tested on actual hardware: We ran this cell on an SM-J600F unit and confirmed the BMS accepted the handshake on first boot. The charge IC stepped through trickle, CC, and CV phases without fault flags. Voltage held at 3.85V nominal under screen-on load.
• First-cycle fuel gauge reset: On first use after installation, disable fast charging and run one full discharge-to-charge cycle. This gives the fuel gauge IC time to map the new cell's discharge curve before high-current charging pushes current into an uncalibrated cell.

Sudden shutdown at 20–30% on the replacement cell

A new cell has a slightly different voltage-versus-capacity curve than the depleted original it replaced. The fuel gauge IC still holds the old curve in its coulomb counter. When modem activity or screen brightness spikes current draw, voltage drops sharply at a point the IC thinks is 25% — but the cell is actually at its safe floor. The phone interprets that voltage cliff as a fault and cuts power. One complete discharge cycle down to auto-off followed by a full charge resets the coulomb counter to the new curve and eliminates the false cutoff.

USB fast charge not accepted on first cycle after swap

Samsung's Adaptive Fast Charging handshake runs a brief negotiation between the charger, the USB controller, and the BMS. On a fresh cell with no charge history, the BMS defaults to standard 5V/1A input until it completes one full charge cycle at low current. This is a protection mode, not a fault. Charge the phone once at standard rate using the OEM cable. On the next charge cycle the BMS re-enables the fast-charge current path and the charger negotiates the higher voltage rail normally.