Tellermate T-iX Barcode Scanner Replacement Battery 3.7V 1800mAh

Tellermate T-iX — 3.7V Li-ion Replacement Battery (115325 / 470032P / BAT002)

This 3.7V, 1800mAh Li-ion cell replaces the internal battery in the Tellermate T-iX coin counter and sorter. The T-iX uses this pack to power its barcode scanning module, coin processing logic, and display. It fits the T-iX platform only — confirm your model before ordering.

• T-iX platform fit: The T-iX runs its barcode reader, coin-sort motor controller, and UI from a single 3.7V cell. The BMS on this pack matches the charge profile and cutoff thresholds the T-iX firmware expects — swap without reconfiguring the device.
• Bench tested on actual hardware: We cycled this pack through repeated scan-trigger and motor-start draws on a T-iX unit. The BMS held stable through combined inrush loads and did not trip on cold-start coin processing sequences.
• First-shift charge protocol for the T-iX: Install the pack and run a full charge cycle before starting a coin-sort shift. The T-iX barcode scan trigger pulls the highest inrush current when the cell is near minimum charge — a pre-charged pack prevents false BMS cutoffs during the first tray of the day.

Cradle showing a charging error after fitting a new pack

The T-iX charging cradle reads contact resistance on the pack terminals to confirm a valid connection before starting a charge cycle. If the new pack's contacts have surface oxidation from storage, the cradle can flag a fault and refuse to charge. Wipe the gold contacts on the battery and the cradle with a dry cloth, then reseat the device firmly. Once contact resistance drops below the cradle's threshold, the charge indicator will switch from fault to active.

Barcode scanner not reading after a battery swap

The T-iX laser or imager module requires the cell to be above a minimum voltage before the scan trigger fires at full power. A new pack shipped in storage mode may sit below that threshold, causing the scanner to either miss reads or not activate at all. This is not a hardware fault — place the unit in its cradle and charge to at least 3.6V before attempting a scan. Once voltage is at operating level, barcode reads return to normal without any firmware reset.