TomTom XL IQ GPS Replacement Battery 3.7V 1100mAh

TomTom XL IQ / V3 Series — 3.7V Li-ion Replacement Battery (6027A0093901)

This 3.7V, 1100mAh Li-ion cell replaces the original battery in the TomTom XL IQ and V3 portable GPS navigators, including models 4EM0.001.01 and N14644. The unit measures 53 × 34 × 4mm and matches the original connector and form factor. Capacity figure is taken directly from product specifications — 4.07Wh total.

• XL IQ and V3 shared platform: These models run on the same internal board revision and use an identical voltage rail at 3.7V nominal. The connector pinout and BMS communication protocol are the same across all listed fit models, so one cell covers the full group.
• Bench tested on actual hardware: We cycled this cell through full charge and discharge on a TomTom XL IQ unit. The BMS accepted the cell without fault codes, charge termination triggered correctly at 4.2V, and low-voltage cutoff engaged at the expected threshold.
• Cold-start satellite acquisition after swap: After fitting this cell, power the GPS on outdoors before driving. A full power interruption clears the almanac cache, so the first satellite fix after a battery swap can take 5–10 minutes. Subsequent warm starts drop under one minute once the cache rebuilds.

GPS accuracy reduced at low battery on the XL IQ

As this cell drops below approximately 3.5V under load, the TomTom XL IQ reduces power to the GPS receiver module to extend operation. That reduction cuts receiver sensitivity, which means the unit may drop from a strong multi-satellite fix to a weaker position estimate. The effect shows up as position drift or sluggish map tracking, not as an error message. Swap or charge the battery before it reaches the low-battery warning to keep full receiver performance.

TomTom XL IQ shuts off without warning before the battery icon empties

An aged or deeply discharged cell develops higher internal resistance, which causes voltage to sag sharply under the load of the display and GPS receiver together. The device hits its hardware cutoff threshold — typically around 3.3V — while the fuel gauge still reads partial charge, because the gauge was calibrated to a healthier cell. The result is an abrupt shutdown that looks like a crash. Fitting a fresh cell and running two full charge cycles recalibrates the gauge and restores accurate low-battery warnings.