Google Pixel Watch 3 Compatible Battery G1QME 3.88V 300mAh

Google Pixel Watch 3 — 3.88V Li-Polymer Replacement Battery (G1QME)

This is a 3.88V, 300mAh lithium-polymer cell for the Google Pixel Watch 3 smartwatch. It matches the OEM part number G1QME and fits the compact 24.40 x 22.00 x 4.20mm battery bay. Replace this cell when the original degrades and the watch can no longer hold charge through a full day of active use.

• Pixel Watch 3 platform fit: The Pixel Watch 3 runs a single-cell Li-Polymer architecture with a proprietary BMS handshake tied to cell impedance. Swapping to a matched 3.88V cell keeps the fuel gauge IC reading correctly and avoids false low-battery shutdowns.
• Bench tested on actual hardware: We ran this cell through the Pixel Watch 3 charge cycle on the magnetic dock. The BMS accepted the new cell without fault flags, and the fuel gauge completed its calibration pass during the first full charge.
• Fuel gauge reset after cell swap: After fitting, place the watch immediately on its magnetic charger and charge to 100% before wearing it. The fuel gauge IC on this platform cannot set an accurate state-of-charge reference until it sees a full charge cycle from near-zero following a cell replacement.

Why the Pixel Watch 3 shows inflated battery drain in the first week after a cell swap

A new cell has slightly different internal impedance than the degraded cell the BMS was last calibrated against. For the first several charge cycles, the fuel gauge reports state-of-charge less accurately, which can look like faster drain on the battery indicator. Always-on display and continuous heart rate sampling add a steady baseline current draw that makes this more visible. The discrepancy corrects itself as the BMS logs charge and discharge curves across three to five full cycles. No settings change is needed — let the watch run through normal daily use and the readings stabilise.

Watch not pairing to phone after battery replacement

Removing the battery cuts power entirely, which drops the active Bluetooth Low Energy session between the watch and the paired phone. The phone retains the pairing record but the watch comes back up without a live BLE link. Open the Bluetooth settings on the phone, forget the Pixel Watch 3, then re-initiate pairing from the watch's settings menu. The watch must be on and showing the home screen — not on the charger boot screen — before the phone can complete the handshake.