Sencor SVC 8621TI 22.2V Replacement Battery 2000mAh

Sencor SVC 8621TI — 22.2V Li-ion Replacement Battery (56889/2)

This is a 22.2V, 2000mAh Li-ion battery for the Sencor SVC 8621TI cordless stick vacuum. It replaces OEM part number 56889/2 and fits both the SVC 8621TI and SVC-8621TI variants. Capacity is rated at 44.4Wh — matching the original specification from Sencor.

• SVC 8621TI fit notes: Both model designations — SVC 8621TI and SVC-8621TI — use the same 22.2V cell pack, connector, and BMS communication profile. The hyphenated variant is a regional labelling difference only; the battery is identical across both.
• Bench tested on actual hardware: We ran this cell pack through charge and discharge cycles on the SVC 8621TI platform. The BMS handshook with the charger without error flags, and the protection circuit tripped correctly at overcurrent thresholds during simulated motor-load spikes.
• Dock charging habit on this vacuum: Remove the vacuum from the dock as soon as it reaches a full charge. The SVC 8621TI charger does not drop to a true maintenance mode — it continues pushing low-level current, which accelerates capacity fade in Li-ion cells over repeated cycles.

Suction dropping before the battery indicator reaches low on the SVC 8621TI

This is a voltage sag issue, not a capacity issue. When the motor draws hard against a partial blockage or a clogged filter, internal resistance in a degraded cell causes the pack voltage to dip below the motor's operating threshold before the state-of-charge indicator registers low. The vacuum reads the cell as partially charged but the available current under load is already insufficient. Clear the filter and check for partial blockages first — if suction then holds consistent, the battery was being asked to deliver more than its degraded cells could sustain under restriction.

Motor cuts out mid-clean then restarts after a few seconds

This is a BMS overcurrent trip, not a flat battery. When suction is restricted — blocked filter, clogged nozzle, hair wrap on the brush roll — the motor draws sustained current above the pack's rated limit. The BMS cuts power to protect the cells, then resets once current demand drops. The trip-and-recover cycle will repeat until the restriction is cleared. Clean or replace the filter, clear the brush roll, then restart — if the motor runs without cutting out, the BMS was responding correctly to a load fault, not a battery fault.