BlueBird BAT-170L Pidion BM-170 Barcode Scanner Compatible Battery 3.7V 3300mAh

BlueBird Pidion BM-170 / BM-170 Semi-Rugged — 3.7V Li-ion Replacement Battery (BAT-170L)

This is a 3.7V, 3300mAh Li-ion battery pack for the BlueBird Pidion BM-170 and BM-170 Semi-Rugged handheld mobile computers. It replaces OEM part BAT-170L and fits the same battery bay without modification. Voltage and capacity match the original specification exactly.

• BM-170 and BM-170 Semi-Rugged fit: Both models use the same 3.7V single-cell architecture and share the BAT-170L form factor, connector pinout, and BMS handshake protocol — one pack covers both variants.
• Bench tested on actual hardware: We cycled this pack through repeated scan-trigger and wireless polling loads. The BMS held voltage within spec across burst scanning sequences and did not false-trip on inrush from the imager or the radio module.
• First shift prep on the BM-170: After installing a new pack, seat the scanner in its cradle and run a full charge cycle before the first shift. The scan trigger draws its highest inrush current when the cell is near minimum — a fully charged cell prevents the BMS from cutting out on the very first pick-and-pack run.

Cradle showing a charging error on a new BAT-170L pack

A charging error on a new pack is almost always a contact resistance issue, not a pack fault. Dock contacts on heavily used cradles accumulate oxidation and debris that interrupt the charge handshake. Remove the pack, wipe the gold contact strips on both the pack and the cradle with a dry lint-free cloth, then reseat firmly. If the error clears, the pack is fine — the dock contacts just needed a clean surface to read the pack's thermistor signal correctly.

Scanner dropping wireless connection during rapid scan bursts

When the BM-170 fires the imager and transmits a scan result simultaneously, the combined inrush from the scan trigger and the wireless radio module spikes the draw on the cell. If the battery is aged or the cell voltage is already low, that spike causes a brief voltage sag that the wireless module interprets as a power loss — dropping the connection. This is not a radio fault. Keeping the pack charged above 30% during active pick-and-pack shifts eliminates the sag. A fresh BAT-170L cell holds voltage tighter under combined load, which is where you notice the difference versus a degraded original pack.