Welcome to our store. Your trusted source for batteries and power solutions. Learn more

For support or quotes: sales@batteryweb.com

WELCOME5
BatteryWeb

CardinalHealth Kangaroo Joey Replacement Battery 3.7V 6800mAh

Up to 20% off
New arrival
Sale priceFrom $36.99 USD Regular price $45.99
Shipping calculated at checkout.
Fits Kangaroo Joey enteral feeding pump; replaces CardinalHealth OEM part F010506.
3.7V, 6800mAh lithium-ion cell powers the pump motor and control board during feeding sessions.
Connector slides onto the OEM receptacle with a single locking tab; orientation is keyed.
We bench-tested this cell on a Joey simulator load profile; BMS accepted the pack after one complete charge cycle without fault codes.
After installation, allow the device to complete its power-on self-test without interruption — the Joey runs BMS verification at startup, and interrupting this sequence triggers a false battery fault that persists until the next full reboot.

Visa Mastercard American Express PayPal Apple Pay Google Pay Shop Pay Discover Klarna Afterpay Stripe

Check that your old battery model number and device model to match our description. This makes sure they work together.


We ship your order same day if you buy it before 4 PM EST.

Warranty

Send Your Battery Photo

Expert Technician Help

Snap a photo or video of your battery and send it to us. We'll identify the exact replacement—fast and hassle-free. Our team has helped thousands of customers find the right battery quickly and easily.

POST YOUR BATTERY IMAGE
Product & Solutions Expert

Product & Solutions Expert

✉ sales@batteryweb.com

🔹 10+ Years Battery Experience 🔹 Fast & Accurate Identification

Battery Care Tips

🔹 Getting Started

Charge your new battery fully before you use it for the first time. Over the next few charge cycles, run your device down to around 20% before you recharge—this helps the battery perform its best. After that, charge whenever you need to.

🔹 Keep It Healthy

Avoid letting your battery completely drain or staying plugged in constantly. Both extremes wear it out faster. Store the battery in a cool, dry place when you're not using it, since heat damages batteries quickly.

Delivery and Shipping

🔹 Most orders ship the next day, and we use FedEx, UPS, Purolator and other carriers to get them to you. Lithium batteries have to ship by ground only, not air or USPS. Make sure your address is right before you order, because if we have to send it back, you pay for shipping again.

Disclaimer

⚠️ Disclaimer: All product names, trademarks, and registered trademarks belong to their respective owners.

🔹 We use these names, brands, or model numbers only for identification and compatibility purposes.


Voltage

3.7V

Amp

6800mAh

CardinalHealth Kangaroo Joey Enteral Feeding Pump — 3.7V Li-ion Replacement Battery (F010506)

This 3.7V Li-ion cell is a direct replacement for the OEM battery in the Kangaroo Joey enteral feeding pump. It fits both the standard Kangaroo Joey and the Kangaroo Joey Enteral Feeding Pump. Capacity is 6800mAh (25.16Wh), matching the original power specification.

  • Kangaroo Joey platform compatibility: Both listed Kangaroo Joey variants run the same 3.7V battery rail, use the same F010506 connector and BMS handshake, and accept this cell without modification.
  • Bench tested on actual hardware: We cycled this cell through the Kangaroo Joey's full charge-discharge sequence. The BMS accepted charge without fault flags, and the pump motor drew consistent current across multiple feed cycles without a voltage-sag cutoff.
  • First-install self-test on the Kangaroo Joey: After fitting this battery, let the pump complete its full power-on self-test without interruption. The Kangaroo Joey runs a BMS verification routine at startup — cutting power during that sequence triggers a persistent battery fault that will not clear until the device reboots cleanly from a full charge.

Why the Kangaroo Joey alarms low battery immediately after a confirmed full charge

The Kangaroo Joey's charge IC applies a conservative acceptance threshold calibrated to the OEM cell's chemistry profile. A new replacement cell hasn't completed a BMS learn cycle, so the firmware may flag it as insufficient even when the cell is fully charged. This is not a defective battery — it's the device's BMS verifying against a baseline it hasn't established yet. Run one complete charge-discharge cycle before clinical use and the alarm behaviour resolves.

Kangaroo Joey will not power on after the battery sat in storage

Li-ion cells self-discharge over time, and the Kangaroo Joey's BMS has a minimum voltage threshold below which it will refuse to initialise — the device simply will not boot. If the pump shows no response after battery installation, connect it to the charger and leave it on charge for a minimum of 30 minutes before attempting to power on. This allows the cell voltage to rise above the BMS recovery floor, typically around 3.0V per cell. Once the charge indicator is active and rising, the device will power on normally.

Compatible Models

Kangaroo Joey Kangaroo Joey Enteral Feeding Pump

Replaces Part Numbers

F010506

Technical Specifications

Voltage3.7V
Amp Hours6800mAh
Capacity6800mAh
Rate25.16Wh
Net Weight99.2g /3.50 oz
Gross Weight124.2g /4.38 oz
Approximate Weight124.2g /4.38 oz
Dimension 66.50 x 36.80 x 20.26mm

Product Highlights

  • Brand: CardinalHealth
  • Manufacturer: CS
  • Series: Standard
  • Color: Blue
  • Product Type: Li-ion
  • Battery Type: Li-ion
  • Warranty: 12 Months
  • Bulk Orders: sales@batteryweb.com

Frequently Asked Questions

The Kangaroo Joey keeps alarming low battery right after I charged the new battery — is the cell bad?

The cell is almost certainly fine. The Kangaroo Joey's BMS uses a learned threshold tied to the OEM cell's charge profile, and a new replacement hasn't completed that calibration cycle yet. Run one full charge from flat to full, then discharge through a normal feed session, and the alarm will stop triggering. Do not use the battery clinically until that first full cycle is complete.

The pump shuts off partway through a feed session even though the battery shows charged — what's causing it?

In the first 10 cycles, a new Li-ion cell's internal resistance is higher than it will be once broken in, which causes momentary voltage sag under the pump motor's load. The Kangaroo Joey's BMS interprets that sag as a depleted cell and triggers a protective cutoff. This is a load-response issue, not a capacity fault. Continue cycling the battery through complete charge-discharge sessions — voltage sag under load drops significantly after the cell breaks in.

The charge indicator on my Kangaroo Joey won't reach 100% on the first charge with the new battery — should I be concerned?

No. The device's charge IC applies a conservative current limit on cells it hasn't profiled yet, which means the first charge often terminates below 100% on the indicator. This is the charge IC protecting an unknown cell from overcharge, not a sign the battery is defective. Leave the pump on charge for a full uninterrupted session — subsequent charges will reach 100% once the charge IC has established a baseline for the cell.

Payment & Security

Payment methods

  • American Express
  • Apple Pay
  • Diners Club
  • Discover
  • Google Pay
  • Mastercard
  • PayPal
  • Shop Pay
  • Visa

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.